Regardless whether it’s for your own personal security, for roadworthiness tests or to avoid a fine, ensuring your headlamp bulbs are in every case working is necessary. Indeed, bulbs are wearing auto parts that will inevitably burn out over the years and consequently need to be swapped out. You’re quite likely on this website because one of your parking lights is burnt out and you’re struggling with how to change your Volkswagen ID.3’s license plate bulb, we’ve written this article to help you do it by yourself and not have to go to your technician. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Volkswagen ID.3.
How to swap the license plate bulb on your Volkswagen ID.3 throughout the outside
This solution is the most simple of the two, in fact, for this one you will just have to take off the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the situation we will dedicate some time on in the second section of this article content to show you the approach.
So let’s begin with swapping the number plate bulb by going through the outside of your Volkswagen ID.3. Regardless whether it’s the front or the back of your vehicle the technique will be identical.
Here are a few simple actions to stick to to conduct this service:
- With the engine turned off, disconnect the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to insert the flat part into the notch specified for this goal (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Volkswagen ID.3
- Use your screwdriver or knife to eject the bulb from its place, in the event you are worried of destroying a thing, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and check the light to confirm the achievement of the task.
.
How to change the number plate bulb on your Volkswagen ID.3 without outside access
Second section of our article, swap this license plate bulb on your Volkswagen ID.3 without external access. In most cases you will be able to access it, but some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Volkswagen ID.3
To swap the one on the front plate, nothing could be less complicated, you will have to position yourself under the vehicle (preferably placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general kept by two soft plastic tabs by pressing on both at once, then right after you have your license plate bulb block in hand, Take out the plastic that works as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be careful not to put in too much pressure otherwise you will break the plastic cover), and you will just have to take off the burnt-out license plate bulb and replace it with the new , then test out and reassemble the whole thing.
How to swap the rear license plate bulb on my Volkswagen ID.3
Finally last solution, you must swap the bulb on the backplate of your Volkswagen ID.3, but you cannot really open the cover from the outside of your vehicle. In this case, here is the tactic to carry out this operation:
- Unplug the battery from your Volkswagen ID.3
- Find the location of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever softly on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, disconnect the holders for less difficult access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Volkswagen ID.3, check it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have found out the main tactics for swapping license plate bulbs on your car, take notice that on some models the methodology may be a bit different but you should be able to realize it following the outline of this document. If you can’t do it, don’t be reluctant to go to your garage area it would be a shame to break a part of your Volkswagen ID.3. If you desire to change other bulbs like the position light bulbs on your Volkswagen ID.3 or the low beam bulbs on Volkswagen ID.3, don’t be reluctant to read our articles which describe you the process to follow.
If you need more guides on the Volkswagen ID.3, go to our Volkswagen ID.3 category.
