Today we’re going to tackle one more matter in the series on motor vehicle care. This is the coolant level, and specifically where to put coolant in hyundai i10? For this, we will begin this content page with a little reminder on the interest of ensuring of the coolant level of your motor vehicle, then, where to fill coolant in hyundai i10? And, finally, how to make the level of this famous liquid.

put-coolant-hyundai-i10

Why to fill coolant level on a hyundai i10?

Before we explain where the coolant is on a hyundai i10, we begin our article by reminding you what is the interest of ensuring an ideal coolant level ? The coolant of a hyundai i10 has an important function in the good functioning of your engine, in fact, it will circulate in it to catch the heat produced by its process and transfer it to your radiator which has the mission to make it go down in temperature . It is all the more useful when outside temperatures are high or when you are driving at limited speed and natural cooling by outside air is not useful. Without coolant your engine would overheat after only a few minutes, and this would result in engine failure, hence the importance of having an ideal coolant level at all times. If your coolant level drops down below the minimum level, the circulation of the coolant in the cooling system might be reduced and therefore its performance might be limited or even zero if it is too low. At last, if it is too high, the pressure can be too high and bring about a leak that can also bring about the engine to break down.

Where to put the coolant in hyundai i10?

We now move on to the step that you are probably most interested in, where to put coolant in hyundai i10? You are now aware of the importance of always having the ideal level of this coolant. To identify it is very simple, here are the different steps to allow you to locate the expansion tank that contains the coolant of your hyundai i10:

  • Before doing anything, wait a few minutes or so for your engine to warm up so that you don’t get burned when you do the coolant level.
  • Pop the hood of your motor vehicle.
  • You must quickly identify the expansion tank that contains the coolant of your hyundai i10, it is usually located in one of the 4 corners of your engine block, to identify it you just have to look for a plastic container with a black or yellow plastic cap with a danger logo or thermometer on the top.

How to fill up the coolant level on a hyundai i10?

Now that you have identify where the coolant is in your hyundai i10 , we will explain how to make the level of it. Nothing could be less complicated, just stick to the few steps down below:

  • Buy if you don’t have any coolant in the store, it’s just treated water with antifreeze added.
  • Verify on the side of the expansion tank of your hyundai i10 the level of the expansion tank. Just see if you are between the “min” and “max” mark, if you are more towards or down below the “min” mark you can continue to stick to these steps, in any other case the level of your liquid is good enough

    • .

  • After waiting for the engine to cool down, you can open the coolant cap of your motor vehicle.
  • Carefully add coolant to the expansion tank of your hyundai i10 by looking at frequently.
  • Try to reach the middle of the clue on the side of your vase, don’t go over the “max” mark.
  • If you’re on top of it, don’t begin your engine, and with a syringe, take out the excess coolant.

If the engine of your hyundai i10 warms up despite a level coolant, go through this article, you will be able to find the causes of this problem.

If perhaps you have any additional questions about the hyundai i10, do not hesitate to consult our hyundai i10 category.