When your car is running normally everything is fine, nevertheless if it begins to have regular problems you may begin to question, specifically if your motor vehicle won’t start. In this post we will learn you where the starter of a Citroen C6 is, it will help you to fix your ignition problems. To do this, we will first explain the function of a starter, then, where is the starter on a Citroen C6 , and, at last, how to change the starter of a motor vehicle.

find-starter-citroen-c6

Purpose of the starter on your Citroen C6

We begin this article by explaining the function of the starter motor on your Citroen C6. The starter is an electric motor which is powered by your battery, its job will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is built from three most important parts:

  • The Solenoid: This component is an electrical relay that will act as a switch, it will be activated by the key of your Citroen C6 and let the current from your battery to the engine of your alternator.

    • The engine: Most important component of your alternator, it is the one that will drive the flywheel of your Citroen C6 and bring about enough speed for your engine to begin.

  • The engagement pinion: This is the last part of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it allows to send the force from the starter to the engine.

Where is the starter on a Citroen C6?

Now that we have quickly described what a starter is and how it works, we will answer the question that most of you have to ask yourselves where is the starter located on a Citroen C6? It is quite easy to locate a starter, in actual fact, it is a large part that will almost always be situated in a similar location. We let you discover the two possible spots for your motor vehicle starter below.

Location of the starter on traditional Citroen C6

First and most general case, where to locate the starter of a Citroen C6 with a conventional motor (implied without start and stop). The starter has a specific objective, to start the engine of your motor vehicle, for that, it must always be near the engine flywheel of this one because it is the part that it actuates when it is used. The flywheel is located at the junction between your gearbox and your engine.

Location of the starter to Citroen C6 with start and stop

And now second possible starter location of your Citroen C6 . This case is much less frequent. It only is about engines equipped with start and stop, and a good part of them will be equipped with a starter situated close to the flywheel. However, on some specific series or engines, the starter of your Citroen C6 might be included in your alternator, it is then known as a starter-alternator, to locate it nothing less difficult, identify your accessory belt and you should see the big starter block.

How to change the starter on a Citroen C6?

Finally, we’ll show you to you actually quite quickly how to change the starter of a Citroen C6. This process is not actually complex, it can be considered by people who have a minimal of basic mechanical knowledge and adapted tools. Follow below the most important steps to perform this intervention:

  • Disconnect the battery on your Citroen C6, if you don’t know how to do it, don’t think twice to seek advice from our article which points out how to do it without taking any risk.
  • After locating your starter, loosen the fasteners that hold it in your engine block, there will usually be 2 or 3

    • .

  • It will be time to disconnect the power cables from the starter motor of your Citroen C6, nevertheless before doing so we recommend you to take a picture of the set up to avoid making a mistake when reassembling.
  • It’s possible that to take out it you may need to take out auto parts like the gimbal.
  • Remount the new starter, being careful when connecting the connectors.
  • Reconnect your battery and test your starter.

If you want more guides on the Citroen C6, go to our Citroen C6 category.