It doesn’t matter if it’s for your personal safety, for roadworthiness testing or to avoid a fine, being sure your headlamp bulbs are always functional is necessary. In reality, bulbs are wearing units that will predictably burn out after a while and therefore need to be replaced. You’re perhaps in this article because one of your parking lights is burnt out and you’re struggling with how to change your Volkswagen Transporter 4’s license plate bulb, we’ve made this document to help you do it by yourself and not have to go to your technician. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Volkswagen Transporter 4.
How to change the license plate bulb on your Volkswagen Transporter 4 coming from the outside
This technique is the fastest of the two, in reality, for this one you will simply need to take away the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the situation we will take a moment on in the second section of this content to describe the way.
So let’s begin with replacing the number plate bulb by going through the outside of your Volkswagen Transporter 4. It doesn’t matter if it’s the front or the back of your motor vehicle the procedure will be the same.
Here are a few simple guidelines to follow to conduct this maintenance tasks:
- With the engine off, disconnect the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to insert the flat part into the notch assigned for this purpose (usually on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Volkswagen Transporter 4
- Use your screwdriver or knife to eject the bulb from its location, in the event you are afraid of damaging a thing, you can also do it with your fingers.
- Finally, position the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and test the light to validate the success of the operation.
.
How to change the number plate bulb on your Volkswagen Transporter 4 without outside access
Second section of our item, replace this license plate bulb on your Volkswagen Transporter 4 without external access. Most often you will be able to access it, nevertheless some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Volkswagen Transporter 4
To change the one on the front plate, nothing could be easier, you will have to position yourself under the motor vehicle (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, usually kept by two soft plastic tabs by pressing on both simultaneously, then once you have your license plate bulb block in hand, Take away the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be cautious not to apply too much pressure otherwise you will break the plastic cover), and you will simply have to take away the burnt-out license plate bulb and change it with the new , then test out and reassemble the whole thing.
How to change the rear license plate bulb on my Volkswagen Transporter 4
Finally last possibility, you must change the bulb on the backplate of your Volkswagen Transporter 4, but you cannot open the cover from the outside of your motor vehicle. In this case, here is the technique to operate this task:
- Unplug the battery from your Volkswagen Transporter 4
- Identify the location of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, disconnect the holders for less difficult access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Volkswagen Transporter 4, test it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have found out the main approaches for replacing license plate bulbs on your car, be aware that on some models the technique may be a bit different but you should be able to realize it following the explanation of this content. If you can’t do it, don’t be reluctant to go to your workshop it would be a shame to break a part of your Volkswagen Transporter 4. If you desire to change other bulbs like the position light bulbs on your Volkswagen Transporter 4 or the low beam bulbs on Volkswagen Transporter 4, don’t be reluctant to consult our content articles which demonstrate you the procedure to follow.
If you want more guides on the Volkswagen Transporter 4, go to our Volkswagen Transporter 4 category.
