Regardless it’s for your specific safety, for roadworthiness tests or to avoid a fine, ensuring your headlamp bulbs are all the time operational is very important. Indeed, bulbs are wearing parts that will obviously burn out with time and consequently need to be changed. You’re almost certainly on this site because one of your parking lights is burnt out and you’re struggling with how to change your Opel Antara’s license plate bulb, we’ve made this content page to help you do it all on your own and not have to go to your motor mechanic. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Opel Antara.
How to change the license plate bulb on your Opel Antara through the outside
This approach is the least difficult of the two, in reality, for this one you will only have to take away the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the situation we will spend some time on in the second section of this article to clarify the method.
So let’s start with changing the number plate bulb by going through the outside of your Opel Antara. Regardless it’s the front or the back of your automobile the procedure will be similar.
Here are a few simple guidelines to stick to to execute this service:
- With the engine off, unplug the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to place the flat part into the notch assigned for this purpose (commonly on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Opel Antara
- Use your screwdriver or knife to remove the bulb from its spot, if you are worried of destroying something, you can also do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and verify the light to validate the success of the operation.
.
How to change the number plate bulb on your Opel Antara without outside access
Second section of our article, swap this license plate bulb on your Opel Antara without external access. In most cases you will be able to access it, but some series (often at the rear does not allow this access).
How to change the front license plate bulb on my Opel Antara
To change the one on the front plate, nothing could be less difficult, you will have to position yourself under the automobile (preferably placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, commonly held by two soft plastic tabs by pressing on both at the same time, then right after you have your license plate bulb block in hand, Take off the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be careful not to exert too much pressure otherwise you will break the plastic cover), and you will just have to take away the burnt-out license plate bulb and change it with the new , then check and reassemble the whole thing.
How to change the rear license plate bulb on my Opel Antara
Finally last option, you must change the bulb on the backplate of your Opel Antara, but you cannot open the cover from the outside of your automobile. In this case, here is the tactic to execute this task:
- Disconnect the battery from your Opel Antara
- Identify the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, unplug the holders for less complicated access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Opel Antara, verify it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have found out the main tactics for changing license plate bulbs on your car, be aware that on some models the method may be a bit different but you should be able to realize it following the outline of this document. If you can’t do it, don’t hesitate to go to your garage area it would be a shame to break a part of your Opel Antara. If you desire to change other bulbs like the position light bulbs on your Opel Antara or the low beam bulbs on Opel Antara, don’t hesitate to read our articles which describe you the procedure to follow.
To get more tips on the Opel Antara, take a look at the Opel Antara category.
