Regardless it’s for your personal safety, for roadworthiness testing or to avoid a fine, being certain your headlamp bulbs are always operational is necessary. In fact, bulbs are wearing units that will inevitably burn out after awhile and consequently need to be changed. You’re most likely on the website because one of your parking lights is burnt out and you’re worried about how to change your Fiat Scudo’s license plate bulb, we’ve created this article to help you do it on your own and not have to go to your auto mechanic. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Fiat Scudo.
How to swap the license plate bulb on your Fiat Scudo throughout the outside
This solution is the quickest of the two, in reality, for this one you will simply require to take out the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the situation we will spend some time on in the second section of this content to describe the way.
So let’s start with changing the number plate bulb by going through the outside of your Fiat Scudo. Regardless it’s the front or the back of your car the procedure will be the same.
Here are a few simple steps to stick to to perform this routine service:
- With the engine off, disconnect the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch provided for this purpose (usually on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Fiat Scudo
- Use your screwdriver or knife to remove the bulb from its placement, if you are scared of destroying anything, you can also do it with your fingers.
- Finally, put the new license plate light bulb
- Last step, before reassembling, reconnect your battery and verify the light to confirm the successfulness of the operation.
.
How to replace the number plate bulb on your Fiat Scudo without outside access
Second section of our document, swap this license plate bulb on your Fiat Scudo without external access. Most often you will be able to access it, but some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Fiat Scudo
To swap the one on the front plate, nothing could be less complicated, you will have to put yourself under the car (ideally positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, usually held by two soft plastic tabs by pressing on both at the same time, then right after you have your license plate bulb block in hand, Remove the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (take care not to exert too much pressure otherwise you will break the plastic cover), and you will just have to take out the burnt-out license plate bulb and replace it with the new , then check and reassemble the whole thing.
How to swap the rear license plate bulb on my Fiat Scudo
Finally last solution, you must swap the bulb on the backplate of your Fiat Scudo, but you simply cannot open the cover from the outside of your car. In such a case, here is the method to perform this operation:
- Disconnect the battery from your Fiat Scudo
- Find the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever delicately on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, disconnect the holders for less complicated access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Fiat Scudo, verify it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have learned the main techniques for changing license plate bulbs on your car, be aware that on some models the methodology may be a bit different but you should be able to do it following the explanation of this article content. If you can’t do it, don’t hesitate to go to your garage area it would be a shame to break a part of your Fiat Scudo. If you desire to change other bulbs like the position light bulbs on your Fiat Scudo or the low beam bulbs on Fiat Scudo, don’t hesitate to read our articles which demonstrate you the operation to follow.
If perhaps you have any further questions about the Fiat Scudo, do not hesitate to consult our Fiat Scudo category.
