Regardless whether it’s for your specific safety, for roadworthiness testing or to avoid a fine, being certain your headlamp bulbs are all the time functioning is necessary. Indeed, bulbs are wearing auto parts that will undoubtedly burn out after some time and as a result need to be changed. You’re likely on this website because one of your parking lights is burnt out and you’re struggling with how to change your Hyundai Ix35’s license plate bulb, we’ve made this article to help you do it by yourself and not have to go to your technician. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Hyundai Ix35.
How to swap the license plate bulb on your Hyundai Ix35 through the outside
This process is the quickest of the two, in truth, for this one you will only require to remove the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the case we will spend a moment on in the second section of this document to demonstrate the approach.
So let’s begin with swapping the number plate bulb by going through the outside of your Hyundai Ix35. Regardless whether it’s the front or the back of your car the process will be identical.
Here are a few simple steps to stick to to conduct this maintenance:
- With the engine off, disconnect the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to place the flat part into the notch assigned for this intent (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Hyundai Ix35
- Use your screwdriver or knife to remove the bulb from its place, in the event you are scared of damaging something, you can also do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and check the light to confirm the success of the task.
.
How to replace the number plate bulb on your Hyundai Ix35 without outside access
Second section of our content page, replace this license plate bulb on your Hyundai Ix35 without external access. Most often you will be able to access it, however some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Hyundai Ix35
To swap the one on the front plate, nothing could be simpler, you will have to position yourself under the car (preferably positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general held by two soft plastic tabs by pressing on both at the same time, then once you have your license plate bulb block in hand, Take off the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be careful not to apply too much pressure otherwise you will break the plastic cover), and you will just have to remove the burnt-out license plate bulb and replace it with the new , then test out and reassemble the whole thing.
How to swap the rear license plate bulb on my Hyundai Ix35
Finally last solution, you must swap the bulb on the backplate of your Hyundai Ix35, but you cannot open the cover from the outside of your car. In this case, here is the technique to carry out this operation:
- Unplug the battery from your Hyundai Ix35
- Identify the spot of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, disconnect the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Hyundai Ix35, check it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have found out the main techniques for swapping license plate bulbs on your car, be aware that on some models the method may be a bit different but you should be able to accomplish it following the outline of this document. If you can’t do it, don’t be reluctant to go to your workshop it would be a shame to break a part of your Hyundai Ix35. If you wish to change other bulbs like the position light bulbs on your Hyundai Ix35 or the low beam bulbs on Hyundai Ix35, don’t be reluctant to read our articles which explain you the procedure to follow.
In the event that you have any further questions about the Hyundai Ix35, do not hesitate to consult our Hyundai Ix35 category.
