If you’re a bit of a do-it-yourselfer, you’re most likely wanting to manage most of the work to be done on your Ford Ranger, but some are more complicated than others and require the removal of body parts or components to access the component you want to operate on. We want to help you in this operation. That’s why on this web page we are going to discover how to remove the bumper from a Ford Ranger. This action is not very complicated and you should be able to do it with few tools. To accomplish this, first we will see how to remove the front bumper of your Ford Ranger, then how to remove the rear bumper of this one.
How to remove the front bumper from a Ford Ranger
So let’s commence our document with the front bumper of your Ford Ranger. To take it off, you will just need a set of ratchet wrenches, some screwdrivers and torx bits. Here are the simple steps you will have to adhere to in order to disassemble the bumper of your Ford Ranger in good conditions:
- If you want to be more relaxed, we recommend you to put your Ford Ranger on stands and to remove the front wheels to have a good access to the whole front bumper.
- Open the bonnet of your automobile: Would seem obvious, but you will need to have access to the bumper attachment in your engine compartment.
- Take off the wheel arches: They’re also identified as fenders, but they’ll get in the way and stop you from accessing all the screws on the front bumper of your Ford Ranger. According to your car features and the year of your model, you will also have the ability to find staples, to get this done, you will just have to use a staple extractor or to do it gently with a big flat screwdriver, and use a lever to open the staple.
- Then you will have to unscrew the screws that is from behind your mudguard and that fastens the front bumper of your Ford Ranger on the sides.
- Unscrew the screws or remove the clips on the upper part of the bumper in the engine compartment.
- Now it’s time to go beneath your Ford Ranger to unscrew the bolts that are on the chassis of the car, you will find some in the middle of the bumper and on the sides.
- Be sure you unplug the connection of the plate lighting and the distance control sensor if you have it.
- Carefully remove the front bumper by first unclipping the sides. If it doesn’t come off, you perhaps forgot a screw or a clip. Think of working with a carpet or other to prevent that it gets scratched by touching the ground.
That’s it, you’ve seen all the steps of how to remove the front bumper from your Ford Ranger, to put it back in place adhere to the steps in the opposite way.
How to remove the rear bumper from a Ford Ranger
And to conclude, regardless if the operation is quite similar, we will take a look at the case of removing the rear bumper from your Ford Ranger. For each step to avoid repeating ourselves we will simply give you the broad highlights, refer to part 1 if you have any uncertainties or questions for more information.
- Start with performing the same first step, that is, lift your Ford Ranger and take off your rear wheels in order to have an ideal working area to remove the bumper of your Ford Ranger without trouble
- Remove the rear wheel arches of your Ford Ranger to access the side bumper side brackets
- Open your trunk
- Take off the side brackets in your wheel arches to make it less difficult to remove the bumper from your Ford Ranger.
- Take out the lower bindings below your Ford Ranger.
- At the same time, remember to un plug the rear license plate light and the reverse radar sensors if you are equipped with them.
- Unscrew the top brackets from the top of the trunk.
- Now all you have to do is remove the rear bumper from your Ford Ranger, adhere to the same process as for the front bumper
Here, you have discoverd through these two parts, how to remove the bumper from a Ford Ranger whether it is the front one or the rear one the ways are almost the same and it is enough to be careful to make everything go well.
To discover more tips on the Ford Ranger, take a look at the Ford Ranger category.
