You’re bored with listening to cassettes and only being able to listent to the radio, while your phone is full of your preferred music file but you don’t have a 3.5mm or usb port on your car radio, so you can’t enjoy your car trips to the fullest… That’s precisely why we’ve created this article content to help you, because in this article you’re going to learn about how to install a car radio on your Jeep Gladiator. To achieve this, first of all we will find out how to remove the old car radio, then how to install a car radio on Jeep Gladiator and finally, how to connect it.
How to install car radio on Jeep Gladiator: Removing the old car stereo
Before we begin the serious business of how to install a car stereo on your Jeep Gladiator, there is one imperative task, take out the audio set you already have on your car. There are two scenarios, either you have an original headunit, or you have an universal set. Before you start dismantling, always remember to remove the negative cable from the battery to avoid any risk of short-circuit or electrocution. Once this is conducted, here are the two ways depending on the stereo that equips your Jeep Gladiator:
- Original car radio:
In this instance, you’ll have to be patient, in most cases, the simple use of extracting clamps in the 4 holes in the corners of the car radio should be enough to remove it. But on some specific models of specific years, this procedure will not be enough to remove the old car radio from your Jeep Gladiator. In reality, you will need to remove certain auto parts of the centre console to access the car radio itself. To make this happen, you will need to use a screwdriver to remove the plastic covers that are in the way. Once you have access to the station, remember to disconnect all the connections. - Aftermarket radio :
In this situation the technique is less difficult, you will just have to use the extracting clamps and press on the 4 corners of your station to make it come out of its place. Once this step is conducted, remember to unplug it and remove the metal frame that supports it in the notch of the center console. That’s it, you’ve finished dismantling your old car radio, all you have to do is install the new one!
How to install car radio on your Jeep Gladiator: Fitting and connecting the car radio
Let’s go to the essential part for you, how to install a car stereo on your Jeep Gladiator. Beforehand, spend some time to examine the suitability of your car and your headunit, and to read the installation information, which may give you specific guidelines.
Here are the various steps required in installing an aftermarket car radio. Firstly, put in place the metal frame provided with your new car radio, this frame has the task of holding your car radio in place on your Jeep Gladiator, once situated, remember to press the locking tabs on each side of the frame. Once this step has been done, you will need to connect the three plugs of your car radio, two ISO connectors for power supply and sound transfer to the speakers of your Jeep Gladiator, then the radio antenna socket. For the latter, on some models you may need an adapter to transform it from male to female in order to adapt it to the socket of your new radio. At last, all you have to do is push your car radio into the metal frame, snap it into place, and position the plastic or metal frame provided with it on its contour. That’s it, you’ve just discovered how to install a car radio on Jeep Gladiator, remember to check that the radio is switched on, that the sound is working and that you’re picking up the radio and you’re ready to enjoy your new car radio. If you have other concerns, or want to learn more about your car, don’t be reluctant to visit our page dedicated to it.
In the event that you have any additional questions about the Jeep Gladiator, do not hesitate to consult our Jeep Gladiator category.
