Whether it’s for your specific safety, for roadworthiness testing or to avoid a fine, being certain your headlamp bulbs are in every case working is extremely important. In reality, bulbs are wearing units that will inevitably burn out over time and as a result need to be changed. You’re almost certainly here because one of your parking lights is burnt out and you’re wondering how to change your Toyota Verso’s license plate bulb, we’ve created this document to help you do it on your own and not have to go to your mechanic. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Toyota Verso.
How to replace the license plate bulb on your Toyota Verso throughout the outside
This tactic is the quickest of the two, in reality, for this one you will only need to take out the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the situation we will spend a moment on in the second section of this article content to teach you the way.
So let’s begin with replacing the number plate bulb by going through the outside of your Toyota Verso. Whether it’s the front or the back of your car the technique will be identical.
Here are a few simple steps to stick to to perform this routine service:
- With the engine off, unplug the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to place the flat part into the notch provided for this goal (almost always on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Toyota Verso
- Use your screwdriver or knife to remove the bulb from its place, in the event that you are scared of breaking something, you can also do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and check the light to validate the success of the operation.
.
How to change the number plate bulb on your Toyota Verso without outside access
Second section of our content page, change this license plate bulb on your Toyota Verso without external access. In most cases you will be able to access it, but some series (often at the rear does not allow this access).
How to replace the front license plate bulb on my Toyota Verso
To replace the one on the front plate, nothing could be easier, you will have to position yourself under the car (preferably placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, almost always held by two soft plastic tabs by pressing on both at the same time, then once you have your license plate bulb block in hand, Take out the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be mindful not to put in too much pressure or you will break the plastic cover), and you will only have to take out the burnt-out license plate bulb and change it with the new , then test out and reassemble the whole thing.
How to replace the rear license plate bulb on my Toyota Verso
Finally last possibility, you must replace the bulb on the backplate of your Toyota Verso, but you cannot open the cover from the outside of your car. In this case, here is the method to operate this task:
- Disconnect the battery from your Toyota Verso
- Find the position of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever gently on all the frame of the trunk to remove it.
- Once found, before removing the bulb holders, unplug the holders for less difficult access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Toyota Verso, check it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have discovered the main ways for replacing license plate bulbs on your car, bear in mind that on some models the methodology may be a bit different but you should be able to do it following the outline of this article. If you can’t do it, don’t be reluctant to go to your garage area it would be a shame to break a part of your Toyota Verso. If you wish to change other bulbs like the position light bulbs on your Toyota Verso or the low beam bulbs on Toyota Verso, don’t be reluctant to consult our content articles which describe you the procedure to follow.
To discover more tips on the Toyota Verso, take a look at the Toyota Verso category.
