Whether it’s for your specific security, for roadworthiness tests or to avoid a fine, ensuring that your headlamp bulbs are always effective is very important. In fact, bulbs are wearing parts that will obviously burn out after a while and therefore need to be replaced. You’re most certainly in this article because one of your parking lights is burnt out and you’re wanting to know how to change your skoda fabia’s license plate bulb, we’ve written and published this content to help you do it all on your own and not have to go to your auto technician. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your skoda fabia.
How to change the license plate bulb on your skoda fabia coming from the outside
This technique is the fastest of the two, in fact, for this one you will only have to take out the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the situation we will spend a moment on in the second part of this content page to describe the approach.
So let’s begin with replacing the number plate bulb by going through the outside of your skoda fabia. Whether it’s the front or the back of your motor vehicle the technique will be similar.
Here are a few simple steps to stick to to execute this maintenance:
- With the engine turned off, unplug the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch specified for this purpose (in most cases on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your skoda fabia
- Use your screwdriver or knife to eject the bulb from its placement, if you are worried of breaking something, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and test the light to confirm the success of the procedure.
.
How to replace the number plate bulb on your skoda fabia without outside access
Second part of our content page, replace this license plate bulb on your skoda fabia without external access. In most cases you will be able to access it, nevertheless some series (often at the rear does not allow this access).
How to change the front license plate bulb on my skoda fabia
To change the one on the front plate, nothing could be much easier, you will have to position yourself under the motor vehicle (ideally placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in most cases kept by two soft plastic tabs by pressing on both simultaneously, then once you have your license plate bulb block in hand, Take away the plastic that operates as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be cautious not to put in too much pressure otherwise you will break the plastic cover), and you will just have to take out the burnt-out license plate bulb and swap it with the new , then verify and reassemble the whole thing.
How to change the rear license plate bulb on my skoda fabia
Finally last solution, you must change the bulb on the backplate of your skoda fabia, but you cannot open the cover from the outside of your motor vehicle. In such a case, here is the approach to operate this operation:
- Unplug the battery from your skoda fabia
- Identify the position of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever delicately on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, unplug the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your skoda fabia, test it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have learned the main ways for replacing license plate bulbs on your car, take notice that on some models the method may be a bit different but you should be able to realize it following the explanation of this content. If you can’t do it, don’t hesitate to go to your garage it would be a shame to break a part of your skoda fabia. If you want to change other bulbs like the position light bulbs on your skoda fabia or the low beam bulbs on skoda fabia, don’t hesitate to consult our articles which explain you the operation to follow.
In the event that you have any further questions about the skoda fabia, do not hesitate to consult our skoda fabia category.
