Regardless it’s for your personal safety, for roadworthiness testing or to avoid a fine, being certain your headlamp bulbs are in every case functional is very important. In fact, bulbs are wearing parts that will undoubtedly burn out over the years and consequently need to be changed. You’re perhaps in this article because one of your parking lights is burnt out and you’re struggling with how to change your Nissan Almera’s license plate bulb, we’ve written this document to help you do it on your own and not have to go to your auto mechanic. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Nissan Almera.
How to swap the license plate bulb on your Nissan Almera throughout the outside
This method is the most simple of the two, in fact, for this one you will just require to take out the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the situation we will dedicate a moment on in the second part of this article to demonstrate the method.
So let’s start with changing the number plate bulb by going through the outside of your Nissan Almera. Regardless it’s the front or the back of your automobile the operation will be similar.
Here are a few simple steps to follow to conduct this maintenance:
- With the engine turned off, unplug the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch specified for this intent (almost always on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Nissan Almera
- Use your screwdriver or knife to remove the bulb from its placement, in the event you are scared of damaging a thing, you can as well do it with your fingers.
- Finally, put the new license plate light bulb
- Last step, before reassembling, reconnect your battery and check the light to confirm the successfulness of the task.
.
How to change the number plate bulb on your Nissan Almera without outside access
Second part of our document, replace this license plate bulb on your Nissan Almera without external access. Most often you will be able to access it, however some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Nissan Almera
To swap the one on the front plate, nothing could be much easier, you will have to put yourself under the automobile (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, almost always kept by two soft plastic tabs by pressing on both simultaneously, then right after you have your license plate bulb block in hand, Take out the plastic that works as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be attentive not to apply too much pressure otherwise you will break the plastic cover), and you will only have to take out the burnt-out license plate bulb and change it with the new , then check and reassemble the whole thing.
How to swap the rear license plate bulb on my Nissan Almera
Finally last option, you must swap the bulb on the backplate of your Nissan Almera, but you cannot really open the cover from the outside of your automobile. In such a case, here is the method to operate this task:
- Disconnect the battery from your Nissan Almera
- Find the location of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, unplug the holders for less difficult access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Nissan Almera, check it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have discovered the main approaches for changing license plate bulbs on your car, remember that on some models the technique may be a bit different but you should be able to do it following the explanation of this content. If you can’t do it, don’t hesitate to go to your garage area it would be a shame to break a part of your Nissan Almera. If you want to change other bulbs like the position light bulbs on your Nissan Almera or the low beam bulbs on Nissan Almera, don’t hesitate to browse our articles which demonstrate you the procedure to follow.
To get more tips on the Nissan Almera, take a look at the Nissan Almera category.
