It doesn’t matter if it’s for your personal safety, for roadworthiness testing or to avoid a fine, being sure your headlamp bulbs are all the time operational is necessary. Indeed, bulbs are wearing units that will undoubtedly burn out with time and consequently need to be swapped out. You’re probably in this article because one of your parking lights is burnt out and you’re struggling with how to change your Mercedes Actros’s license plate bulb, we’ve made this article content to help you do it without any help and not have to go to your motor mechanic. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Mercedes Actros.
How to swap the license plate bulb on your Mercedes Actros through the outside
This process is the easiest of the two, actually, for this one you will only have to take out the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the case we will dedicate some time on in the second section of this article content to show you the approach.
So let’s begin with changing the number plate bulb by going through the outside of your Mercedes Actros. It doesn’t matter if it’s the front or the back of your vehicle the method will be the same.
Here are a few simple actions to stick to to conduct this maintenance tasks:
- With the engine turned off, unplug the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to insert the flat part into the notch assigned for this goal (commonly on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Mercedes Actros
- Use your screwdriver or knife to remove the bulb from its placement, in the event you are scared of breaking something, you can as well do it with your fingers.
- Finally, position the new license plate light bulb
- Last step, before reassembling, reconnect your battery and verify the light to validate the success of the task.
.
How to replace the number plate bulb on your Mercedes Actros without outside access
Second section of our content page, replace this license plate bulb on your Mercedes Actros without external access. In most cases you will be able to access it, but some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Mercedes Actros
To swap the one on the front plate, nothing could be less difficult, you will have to position yourself under the vehicle (ideally positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, commonly held by two soft plastic tabs by pressing on both simultaneously, then once you have your license plate bulb block in hand, Take off the plastic that operates as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be cautious not to exert too much pressure or you will break the plastic cover), and you will simply have to take out the burnt-out license plate bulb and change it with the new , then test and reassemble the whole thing.
How to swap the rear license plate bulb on my Mercedes Actros
Finally last possibility, you must swap the bulb on the backplate of your Mercedes Actros, but you are not able to open the cover from the outside of your vehicle. In such a case, here is the solution to carry out this task:
- Disconnect the battery from your Mercedes Actros
- Find the position of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, unplug the holders for less complicated access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Change the burnt-out license plate bulb on your Mercedes Actros, verify it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have found out the main techniques for changing license plate bulbs on your car, bear in mind that on some models the method may be a bit different but you should be able to accomplish it following the explanation of this article. If you can’t do it, don’t hesitate to go to your mechanic it would be a shame to break a part of your Mercedes Actros. If you desire to change other bulbs like the position light bulbs on your Mercedes Actros or the low beam bulbs on Mercedes Actros, don’t hesitate to read our articles which explain you the procedure to follow.
In the event that you have any additional questions about the Mercedes Actros, do not hesitate to consult our Mercedes Actros category.
