Regardless whether it’s for your own security, for roadworthiness testing or to avoid a fine, being certain your headlamp bulbs are in every case operational is extremely important. In reality, bulbs are wearing units that will predictably burn out after a while and therefore need to be replaced. You’re probably on this website because one of your parking lights is burnt out and you’re struggling with how to change your honda jazz’s license plate bulb, we’ve created this document to help you do it without any help and not have to go to your mechanic. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your honda jazz.

change-license-plate-bulb-honda-jazz

How to swap the license plate bulb on your honda jazz coming from the outside

This option is the most simple of the two, in truth, for this one you will just have to remove the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the situation we will spend a moment on in the second section of this content page to demonstrate the way.
So let’s begin with changing the number plate bulb by going through the outside of your honda jazz. Regardless whether it’s the front or the back of your car the technique will be similar.
Here are a few simple guidelines to follow to execute this maintenance:

  • With the engine off, unplug the battery terminals from your car
  • Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch supplied for this intent (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your honda jazz
  • .

  • Use your screwdriver or knife to eject the bulb from its place, in the event that you are afraid of destroying something, you can also do it with your fingers.
  • Finally, put the new license plate light bulb
  • Last step, before reassembling, reconnect your battery and test the light to validate the achievement of the operation.

How to replace the number plate bulb on your honda jazz without outside access

Second section of our item, change this license plate bulb on your honda jazz without external access. In most cases you will be able to access it, but some series (often at the rear does not allow this access).

How to swap the front license plate bulb on my honda jazz

To swap the one on the front plate, nothing could be less hard, you will have to put yourself under the car (ideally positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general held by two soft plastic tabs by pressing on both simultaneously, then once you have your license plate bulb block in hand, Remove the plastic that works as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (take care not to exert too much force or you will break the plastic cover), and you will just have to remove the burnt-out license plate bulb and change it with the new , then verify and reassemble the whole thing.

How to swap the rear license plate bulb on my honda jazz

Finally last option, you must swap the bulb on the backplate of your honda jazz, but you cannot open the cover from the outside of your car. In this instance, here is the technique to carry out this task:

  • Unplug the battery from your honda jazz
  • Identify the spot of your light bulbs from the outside.
  • From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever softly on all the frame of the trunk to remove it.
  • Once found, before removing the bulb holders, unplug the holders for less difficult access.
  • Using a screwdriver, lever the two plastic parts to remove the bulb holder
  • .

  • Change the burnt-out license plate bulb on your honda jazz, test it and reassemble it, paying attention to the clips on the trunk liner

.
There you have it, you have discovered the main ways for changing license plate bulbs on your car, be aware that on some models the methodology may be a bit different but you should be able to accomplish it following the explanation of this content. If you can’t do it, don’t hesitate to go to your garage area it would be a shame to break a part of your honda jazz. If you need to change other bulbs like the position light bulbs on your honda jazz or the low beam bulbs on honda jazz, don’t hesitate to browse our content articles which explain you the operation to follow.

To find more tips on the honda jazz, take a look at the honda jazz category.