It doesn’t matter if it’s for your specific security, for roadworthiness tests or to avoid a fine, being certain your headlamp bulbs are in every case working is fundamental. In fact, bulbs are wearing units that will inevitably burn out over the years and as a consequence need to be replaced. You’re likely on this website because one of your parking lights is burnt out and you’re wondering how to change your GMC Savana’s license plate bulb, we’ve created this content to help you do it without any help and not have to go to your technician. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your GMC Savana.
How to swap the license plate bulb on your GMC Savana throughout the outside
This solution is the quickest of the two, in truth, for this one you will simply require to take out the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the situation we will take some time on in the second section of this content page to explain the way.
So let’s begin with changing the number plate bulb by going through the outside of your GMC Savana. It doesn’t matter if it’s the front or the back of your vehicle the method will be similar.
Here are a few simple guidelines to stick to to conduct this routine service:
- With the engine off, disconnect the battery terminals from your car
- Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch specified for this goal (in general on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your GMC Savana
- Use your screwdriver or knife to remove the bulb from its placement, if you are afraid of breaking a thing, you can as well do it with your fingers.
- Finally, put the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and verify the light to confirm the successfulness of the process.
.
How to change the number plate bulb on your GMC Savana without outside access
Second section of our content page, swap this license plate bulb on your GMC Savana without external access. Most often you will be able to access it, however some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my GMC Savana
To swap the one on the front plate, nothing could be easier, you will have to put yourself under the vehicle (ideally put on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, in general held by two soft plastic tabs by pressing on both at once, then right after you have your license plate bulb block in hand, Take off the plastic that operates as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (take extra care not to exert too much pressure otherwise you will break the plastic cover), and you will just have to take out the burnt-out license plate bulb and change it with the new , then check and reassemble the whole thing.
How to swap the rear license plate bulb on my GMC Savana
Finally last option, you must swap the bulb on the backplate of your GMC Savana, but you are not able to open the cover from the outside of your vehicle. In this instance, here is the method to accomplish this task:
- Unplug the battery from your GMC Savana
- Find the location of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever gently on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, disconnect the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your GMC Savana, verify it and reassemble it, paying attention to the clips on the trunk liner
.
.
There you have it, you have learned the main ways for changing license plate bulbs on your car, remember that on some models the method may be a bit different but you should be able to realize it following the explanation of this document. If you can’t do it, don’t hesitate to go to your garage area it would be a shame to break a part of your GMC Savana. If you need to change other bulbs like the position light bulbs on your GMC Savana or the low beam bulbs on GMC Savana, don’t hesitate to consult our content articles which describe you the procedure to follow.
If you need more guides on the GMC Savana, go to our GMC Savana category.
