Regardless it’s for your own personal safety, for roadworthiness tests or to avoid a fine, being certain your headlamp bulbs are in every case effective is very important. In fact, bulbs are wearing parts that will inevitably burn out after some time and consequently need to be replaced. You’re almost certainly here because one of your parking lights is burnt out and you’re questioning how to change your Mercedes Benz GLC Class’s license plate bulb, we’ve made this article content to help you do it without any help and not have to go to your mechanic. Firstly, we will take a look at changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Mercedes Benz GLC Class.
How to swap the license plate bulb on your Mercedes Benz GLC Class through the outside
This method is the least difficult of the two, in reality, for this one you will only require to take off the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the situation we will take some time on in the second section of this document to demonstrate the method.
So let’s start with swapping the number plate bulb by going through the outside of your Mercedes Benz GLC Class. Regardless it’s the front or the back of your motor vehicle the method will be the same.
Here are a few simple steps to follow to conduct this routine service:
- With the engine off, disconnect the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to insert the flat part into the notch assigned for this purpose (almost always on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Mercedes Benz GLC Class
- Use your screwdriver or knife to eject the bulb from its spot, in the event you are scared of breaking something, you can also do it with your fingers.
- Finally, put the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and verify the light to validate the success of the process.
.
How to change the number plate bulb on your Mercedes Benz GLC Class without outside access
Second section of our article, replace this license plate bulb on your Mercedes Benz GLC Class without external access. Most often you will be able to access it, nevertheless some series (often at the rear does not allow this access).
How to swap the front license plate bulb on my Mercedes Benz GLC Class
To swap the one on the front plate, nothing could be much easier, you will have to put yourself under the motor vehicle (preferably placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, almost always kept by two soft plastic tabs by pressing on both at the same time, then now that you have your license plate bulb block in hand, Take out the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be careful not to put in too much pressure otherwise you will break the plastic cover), and you will simply have to take off the burnt-out license plate bulb and change it with the new , then check and reassemble the whole thing.
How to swap the rear license plate bulb on my Mercedes Benz GLC Class
Finally last possibility, you must swap the bulb on the backplate of your Mercedes Benz GLC Class, but you are not able to open the cover from the outside of your motor vehicle. In this case, here is the approach to perform this operation:
- Disconnect the battery from your Mercedes Benz GLC Class
- Identify the location of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever softly on all the frame of the trunk to remove it.
- Once located, before removing the bulb holders, disconnect the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Mercedes Benz GLC Class, verify it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have found out the main techniques for swapping license plate bulbs on your car, be aware that on some models the method may be a bit different but you should be able to do it following the explanation of this content page. If you can’t do it, don’t hesitate to go to your mechanic it would be a shame to break a part of your Mercedes Benz GLC Class. If you wish to change other bulbs like the position light bulbs on your Mercedes Benz GLC Class or the low beam bulbs on Mercedes Benz GLC Class, don’t hesitate to consult our content articles which explain you the process to follow.
To find more tips on the Mercedes Benz GLC Class, take a look at the Mercedes Benz GLC Class category.
