Whether it’s for your own personal security, for roadworthiness tests or to avoid a fine, ensuring that your headlamp bulbs are in every case functioning is very important. In fact, bulbs are wearing parts that will obviously burn out after some time and therefore need to be replaced. You’re likely on this website because one of your parking lights is burnt out and you’re worried about how to change your Ford F 550’s license plate bulb, we’ve made this article content to help you do it without any help and not have to go to your technician. Firstly, we will examine changing the license plate bulb from the outside, secondly, how to change the license plate bulb without outside access, and thirdly, how to change the rear license plate bulb of your Ford F 550.

change-license-plate-bulb-ford-f-550

How to replace the license plate bulb on your Ford F 550 through the outside

This technique is the easiest of the two, in reality, for this one you will only have to take away the protective covers of the bulbs. Sadly on some years or packages of car these covers do not open from the outside and if this is the situation we will spend some time on in the second part of this document to teach you the approach.
So let’s begin with swapping the number plate bulb by going through the outside of your Ford F 550. Whether it’s the front or the back of your car the technique will be similar.
Here are a few simple guidelines to stick to to conduct this service:

  • With the engine off, unplug the battery terminals from your car
  • Position yourself in front of your license plate and use a flat screwdriver or knife to place the flat part into the notch provided for this intent (commonly on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Ford F 550
  • .

  • Use your screwdriver or knife to remove the bulb from its place, in the event that you are afraid of destroying a thing, you can also do it with your fingers.
  • Finally, put the new license plate light bulb
  • Last step, before reassembling, reconnect your battery and verify the light to validate the success of the procedure.

How to replace the number plate bulb on your Ford F 550 without outside access

Second part of our item, swap this license plate bulb on your Ford F 550 without external access. Most often you will be able to access it, however some series (often at the rear does not allow this access).

How to replace the front license plate bulb on my Ford F 550

To replace the one on the front plate, nothing could be less hard, you will have to put yourself under the car (preferably placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, commonly held by two soft plastic tabs by pressing on both simultaneously, then once you have your license plate bulb block in hand, Take off the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be attentive not to put in too much pressure otherwise you will break the plastic cover), and you will simply have to take away the burnt-out license plate bulb and swap it with the new , then check and reassemble the whole thing.

How to replace the rear license plate bulb on my Ford F 550

Finally last solution, you must replace the bulb on the backplate of your Ford F 550, but you simply cannot open the cover from the outside of your car. In such a case, here is the approach to carry out this task:

  • Unplug the battery from your Ford F 550
  • Identify the position of your light bulbs from the outside.
  • From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever carefully on all the frame of the trunk to remove it.
  • Once located, before removing the bulb holders, unplug the holders for less difficult access.
  • Using a screwdriver, lever the two plastic parts to remove the bulb holder
  • .

  • Replace the burnt-out license plate bulb on your Ford F 550, verify it and reassemble it, paying attention to the clips on the trunk liner

.
There you have it, you have found out the main solutions for swapping license plate bulbs on your car, be aware that on some models the method may be a bit different but you should be able to do it following the outline of this document. If you can’t do it, don’t hesitate to go to your garage area it would be a shame to break a part of your Ford F 550. If you desire to change other bulbs like the position light bulbs on your Ford F 550 or the low beam bulbs on Ford F 550, don’t hesitate to browse our articles which describe you the process to follow.

If you want more tutorials on the Ford F 550, go to our Ford F 550 category.