It doesn’t matter if it’s for your specific security, for roadworthiness tests or to avoid a fine, making sure your headlamp bulbs are in every case effective is really important. Indeed, bulbs are wearing units that will predictably burn out over time and consequently need to be replaced. You’re most certainly on this website because one of your parking lights is burnt out and you’re worried about how to change your Cadillac XT5’s license plate bulb, we’ve created this content to help you do it all on your own and not have to go to your mechanic. Firstly, we will look at changing the license plate bulb from the outside, secondly, how to replace the license plate bulb without outside access, and thirdly, how to replace the rear license plate bulb of your Cadillac XT5.
How to replace the license plate bulb on your Cadillac XT5 through the outside
This solution is the easiest of the two, in truth, for this one you will just require to take away the protective covers of the bulbs. Regrettably on some years or packages of car these covers do not open from the outside and if this is the situation we will take some time on in the second section of this document to show you the method.
So let’s begin with replacing the number plate bulb by going through the outside of your Cadillac XT5. It doesn’t matter if it’s the front or the back of your car the technique will be similar.
Here are a few simple guidelines to follow to execute this service:
- With the engine off, unplug the battery terminals from your car
- Face your license plate and use a flat screwdriver or knife to insert the flat part into the notch supplied for this intent (generally on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Cadillac XT5
- Use your screwdriver or knife to remove the bulb from its spot, in the event you are worried of damaging a thing, you can also do it with your fingers.
- Finally, put the new license plate light bulb
- Last stage, before reassembling, reconnect your battery and test the light to validate the achievement of the process.
.
How to replace the number plate bulb on your Cadillac XT5 without outside access
Second section of our article, swap this license plate bulb on your Cadillac XT5 without external access. In most cases you will be able to access it, however some series (often at the rear does not allow this access).
How to replace the front license plate bulb on my Cadillac XT5
To replace the one on the front plate, nothing could be less hard, you will have to put yourself under the car (ideally positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, generally kept by two soft plastic tabs by pressing on both at once, then now that you have your license plate bulb block in hand, Take off the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be attentive not to exert too much force otherwise you will break the plastic cover), and you will only have to take away the burnt-out license plate bulb and replace it with the new , then check and reassemble the whole thing.
How to replace the rear license plate bulb on my Cadillac XT5
Finally last possibility, you must replace the bulb on the backplate of your Cadillac XT5, but you cannot open the cover from the outside of your car. In this case, here is the process to accomplish this task:
- Disconnect the battery from your Cadillac XT5
- Locate the location of your light bulbs from the outside.
- From the inside of the trunk, you have to remove the lining of the trunk, kept by clips, you will have to lever carefully on all the frame of the trunk to remove it.
- Once established, before removing the bulb holders, unplug the holders for much easier access.
- Using a screwdriver, lever the two plastic parts to remove the bulb holder
- Replace the burnt-out license plate bulb on your Cadillac XT5, test it and reassemble it, watching the clips on the trunk liner
.
.
There you have it, you have found out the main ways for replacing license plate bulbs on your car, remember that on some models the methodology may be a bit different but you should be able to accomplish it following the outline of this content page. If you can’t do it, don’t be reluctant to go to your garage it would be a shame to break a part of your Cadillac XT5. If you desire to change other bulbs like the position light bulbs on your Cadillac XT5 or the low beam bulbs on Cadillac XT5, don’t be reluctant to consult our articles which describe you the process to follow.
To find more tips on the Cadillac XT5, take a look at the Cadillac XT5 category.
