Certain auto parts of your car are vital to its correct performance, and to go further more, essential to your security and that of other users. Your braking system is one of them, and if there’s one thing that must be in good operating order, it’s this one. When you start to have brake problems you need to deal with it right away, that’s why our team has written this article on brake fluid leaks on Chrysler 200 to help you address this matter in the right way and handle it fairly quickly. To accomplish this, we will first see the purpose of brake fluid, then, what causes a brake fluid leak on your Chrysler 200 , and to finish, how to fix such a leak.
What is the purpose of brake fluid on a Chrysler 200?
So we start our article by fairly quickly telling you the purpose of this famous brake fluid in the braking system of your Chrysler 200. To understand, a brake system works with a closed hydraulic circuit, that is to say that you will have rigid hoses filled with brake fluid that are pressurized by the master cylinder, and when you press your brake pedal, your brake fluid will be compressed and will actuate your brake calipers so that they pinch the brake pads on your discs. It is consequently vital that you constantly have the right level of brake fluid on your Chrysler 200, if you don’t know how to carry out this manipulation, seek advice from our article on this subject.
Motives of a brake fluid leak on your Chrysler 200
We now proceed to a more important part to help you understand why you have a brake fluid leak on your Chrysler 200 .
What causes a brake fluid leak on a Chrysler 200?
First, we’ll show you the different possible origins of the leak of your Chrysler 200. Here are the ones down below:
- A damaged brake hose: It’s one of the most general causes, one of the brake hoses has been cut and you lose brake fluid and pressure through this hole.
- A defective master cylinder on Chrysler 200 can lead to leaks on its different entries or exits.
- In most cases this happens when a brake drain has been done lately, and it is quite often not tightened properly.
- Wheel cylinder: Just present on drum brakes, this part can leak and bring about an imbalance in the braking.
How to identify a brake fluid leak on Chrysler 200?
We will now give you the different recommendations and symptoms to interpret to verify that you have a brake fluid leak on your Chrysler 200 , discover them down below:
- If the ABS warning light of your Chrysler 200 is on , you have to verify directly the state of your circuit, do not hesitate to seek advice from our dedicated article to have all the procedures to carry out.
- If your Chrysler 200 pulls to the left or right when you brake you could have a brake fluid leak.
- This is one of the most visible indications, if you feel that your pedal is much less difficult to press down and goes up more slowly, it is very likely that you have a loss of pressure in your brake system.
- More obvious, but if you discover brake fluid on one of these components you are bound to have a leak since this circuit is designed to be closed.
How to correct a brake fluid leak on Chrysler 200?
The only solution when you experience a brake fluid leak on your Chrysler 200 is to go to your garage. If it is light, check your level and drive carefully to the garage, if it is too big don’t drive and have your motor vehicle towed. A general breakdown of your brake system will lead to an accident. You can, however, make a few frequent checks to limit the risks:
- check the brake fluid level repeatedly.
- Purge your brakes every two years or 40, 000 miles.
- Replace the brake fluid if you feel the brakes on your Chrysler 200 become “soft”.
Whenever you have any additional questions about the Chrysler 200, do not hesitate to consult our Chrysler 200 category.
