We will try again in this article to help you to solve the small complications associated with your car. We have not too long ago seen how to unblock a fuel door, or a tank cap, in this article we will look into an irritating problem that can be dangerous in bad climate conditions, being a victim of wiper stuck on BENTLEY CONTINENTAL . And to correct this, we will first try to figure out why the wipers on your BENTLEY CONTINENTAL remain stuck and, secondly, how to unblock them.

wiper-stuck-bentler-continental

Why does the wiper of my BENTLEY CONTINENTAL stay stuck?

So we will begin our content page with the explanations of the stuck wipers of your BENTLEY CONTINENTAL . First of all we will look into the front wipers and in a second time on the rear wiper.

Why are the front wipers on my BENTLEY CONTINENTAL stuck in up or down position?

We will move through one by one the different complications that can cause the front wipers of your BENTLEY CONTINENTAL to get stuck :

  • One of the most basic motives of front wipers getting stuck on your BENTLEY CONTINENTAL is associated with the engine unit that drives them, in reality, these engines can, over time, lose power, and sooner or later need to be changed. You should notice before the total blockage of your windshield wipers that they work much slower.
  • Less basic, but it can still happen, is that your front wiper blades are blocked because of an object that prevents the blades from functioning, take a look up to the axis of the blades.
  • If it is a lack of lubrication, you will find that your front wipers are going slower, check quickly the trigger of the problems or else the engines will be forced and damaged.
  • It is possible that the front wipers of your BENTLEY CONTINENTAL may not operate because of a defective comodo. To test this, you need to disconnect the output wires and connect them together, if the wipers are functioning, the comodo is responsible for the problem.
  • Finally, last possibility, the front wipers of your BENTLEY CONTINENTAL are blocked because of a power failure, so you will have to check two parts, the relay and the fuse.

Why is the rear window wiper on my BENTLEY CONTINENTAL stuck?

Concerning the stuck rear window wiper of your BENTLEY CONTINENTAL , the origins of your problems are more or less the same. Although there is just one wiper blade at the rear of your car, there are still some dedicated parts that can cause complications just on the rear windshield of your BENTLEY CONTINENTAL . So, make sure you carry out similar investigations as seen in the previous component of this content page.

What can I do to unlock the wiper on my BENTLEY CONTINENTAL ?

At last, for this second section, we will see what solutions are available to you to make sure that the wipers on your BENTLEY CONTINENTAL are unlocked and that they operate properly again.

How to unlock the wipers of my BENTLEY CONTINENTAL ?

Whether it is for the front windshield wipers or the rear windshield wiper, the solutions will be similar and we will highlight them one after the other in this component, it is up to you to adapt them to the component that concerns you. If you have other blocking complications such as a fuel door stuck on BENTLEY CONTINENTAL , do not think twice to seek advice from our article on this problem.

  • In such a case, you will have to identify the engine unit, then disconnect the power cables of this one (be careful there must be several of them associated with the different speeds of sweeping), then take out the brushes and the linkage. At last, you will have to unscrew these anchoring points which are generally fixed on silentblocks and reassemble a new wiper motor on your BENTLEY CONTINENTAL

    • .

  • In this situation, it will be quite very easy but expensive to replace your commodo, the component generally costs around 200€, once tested you will have the ability to disassemble your commodo by removing the cover from the back of the steering wheel then disconnecting it and removing it with the fixing screws, you will just have to reassemble the new one.
  • BENTLEY CONTINENTAL wiper blocked due to a power failure: In this last situation, you will have to identify the origin of the failure (fuse or relay) and replace the defective component

.

To get more tips on the BENTLEY CONTINENTAL , take a look at the BENTLEY CONTINENTAL category.