Today we’re going to deal with one more matter in the series on car care. This is the coolant level, and specifically where to put coolant in Ford Flex? For this, we will begin this article with a little reminder on the interest of making sure of the coolant level of your car, then, where to fill coolant in Ford Flex? And, at last, how to make the level of this famous liquid.

put-coolant-ford-flex

Why to fill coolant level on a Ford Flex?

Before we show you where the coolant is on a Ford Flex, we begin our content page by reminding you what is the interest of guaranteeing an ideal coolant level ? The coolant of a Ford Flex has an important objective in the good functioning of your engine unit, in fact, it will circulate in it to catch the heat produced by its operation and transfer it to your radiator which has the mission to make it go down in temperature . It is all the more useful when outside temperatures are high or when you are driving at limited speed and natural cooling by outside air is not effective. Without coolant your engine unit would overheat after only a few minutes, and this would result in engine unit failure, hence the importance of having an ideal coolant level at all times. If your coolant level drops below the minimal level, the circulation of the coolant in the cooling system might be reduced and therefore its performance might be limited or even zero if it is too low. At last, if it is too high, the pressure can be too high and trigger a leak that can also trigger the engine unit to break down.

Where to put the coolant in Ford Flex?

We now move on to the step that you are probably most enthusiastic about, where to put coolant in Ford Flex? You are now informed of the importance of constantly having the ideal level of this coolant. To locate it is very simple, here are the different steps to allow you to locate the expansion tank that contains the coolant of your Ford Flex:

  • Before doing anything, wait a few minutes or so for your engine to warm up so that you don’t get burned when you do the coolant level.
  • Pop the hood of your car.
  • You must quickly locate the expansion tank that contains the coolant of your Ford Flex, it is in most cases located in one of the 4 corners of your engine block, to locate it you just have to look for a plastic container with a black or yellow plastic cap with a danger logo or thermometer on the top.

How to fill up the coolant level on a Ford Flex?

Now that you have find out where the coolant is in your Ford Flex , we will show you how to make the level of it. Nothing could be easier, just stick to the few steps below:

  • Buy if you don’t have any coolant in the store, it’s just treated water with antifreeze added.
  • Verify on the side of the expansion tank of your Ford Flex the level of the expansion tank. Just see if you are between the “min” and “max” mark, if you are more towards or below the “min” mark you can continue to stick to these steps, otherwise the level of your liquid is good enough

    • .

  • After waiting for the engine to cool down, you can open the coolant cap of your car.
  • Carefully add coolant to the expansion tank of your Ford Flex by checking frequently.
  • Try to reach the middle of the clue on the side of your vase, don’t go over the “max” mark.
  • If you’re on top of it, don’t begin your engine unit, and with a syringe, remove the excess coolant.

If the engine unit of your Ford Flex warms up despite a level coolant, go through this content page, you will have the ability to find the causes of this problem.

If you have any additional questions about the Ford Flex, do not hesitate to consult our Ford Flex category.