When your car is running normally everything is fine, nevertheless if it begins to have frequent problems you may possibly begin to question, especially if your car won’t start. In this post we will teach you where the starter of a Honda Pilot is, it will help you to solve your ignition problems. To do this, we will first illustrate the purpose of a starter, then, where is the starter on a Honda Pilot , and, finally, how to change the starter of a car.
Function of the starter on your Honda Pilot
We begin this article by detailing the purpose of the starter motor on your Honda Pilot. The starter is an electric motor which is powered by your battery, its role will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is built from three main parts:
- The Solenoid: This component is an electrical relay that will work as a switch, it will be activated by the key of your Honda Pilot and let the current from your battery to the engine unit of your alternator.
- The engagement pinion: This is the last component of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it allows to transmit the force from the starter to the engine.
The engine unit: Main component of your alternator, it is the one that will drive the flywheel of your Honda Pilot and bring about enough speed for your engine unit to begin.
Where is the starter on a Honda Pilot?
Now that we have quickly explained what a starter is and how it works, we will answer the question that most of you have to ask yourselves where is the starter based on a Honda Pilot? It is quite easy to locate a starter, in fact, it is a large component that will almost always be placed in a similar location. We let you see the two possible locations for your car starter down below.
Location of the starter on traditional Honda Pilot
First and most basic circumstance, where to locate the starter of a Honda Pilot with a conventional motor (implied without start and stop). The starter has a specific function, to start the engine unit of your car, for that, it must always be near the engine unit flywheel of this one because it is the component that it actuates when it is used. The flywheel is based at the junction between your gearbox and your engine unit.
Location of the starter to Honda Pilot with start and stop
And now second possible starter location of your Honda Pilot . This case is much less frequent. It just concerns engines built with start and stop, and a good component of them will be equipped with a starter placed close to the flywheel. However, on some specific series or engines, the starter of your Honda Pilot might be built in in your alternator, it is then named a starter-alternator, to locate it nothing easier, find your accessory belt and you should see the big starter block.
How to change the starter on a Honda Pilot?
Finally, we’ll show you to you actually quite quickly how to change the starter of a Honda Pilot. This process is not actually complex, it can be considered by people who have a lowest of simple mechanical knowledge and adapted tools. Follow down below the main steps to carry out this intervention:
- Disconnect the battery on your Honda Pilot, if you don’t know how to do it, don’t hesitate to seek advice from our article which points out how to do it without taking any risk.
- After locating your starter, loosen the fasteners that hold it in your engine unit block, there will in most cases be 2 or 3
- It will be time to disconnect the power cables from the starter motor of your Honda Pilot, nevertheless before doing so we advise you to take a picture of the installation to avoid making a mistake when reassembling.
- It’s possible that to remove it you may possibly need to remove parts like the gimbal.
- Remount the new starter, being careful when connecting the connectors.
- Reconnect your battery and test your starter.
.
Whenever you have any further questions about the Honda Pilot, do not hesitate to consult our Honda Pilot category.
