Keeping an eye on your car is essential in these modern times, in reality, if you do not do the minimum routine service of it, or if you do not consider signals of abnormality, you strongly risk to see your car becoming unpleasant to use. This is exactly the topic we are going to discuss in this article, one of the indications that most disturbs motorists is the key indicator light on BENTLEY CONTINENTAL dash . To try to help you analyze this light, first we will see what this key light on BENTLEY CONTINENTAL points, then in a second how to proceed if the key light is lit on BENTLEY CONTINENTAL ? .

key-light-stays-on-bentler-continental

What does the key light on BENTLEY CONTINENTAL indicate?

So we begin our article with the meaning of a key indicator light on BENTLEY CONTINENTAL dash , it may be that in addition to the key you have the logo of a car next to it. Be aware that the main objective of this light is to notify you that it’s time to service your BENTLEY CONTINENTAL , nevertheless, this light can also have other explanations, even dozens of them. To discover the source of this issue the best remedy will be to run your BENTLEY CONTINENTAL through the diagnostic too l, if you don’t know how to achieve this procedure, you can discover all the required info to conduct this act in our dedicated article. We will try in the following list to give you the maximum info on the main alert information it can send you:

  • An oil replace done without resetting the indicator: If you have done your oil replace on your own, it is very likely that you have not thought of resetting the oil change indicator of your BENTLEY CONTINENTAL , here is the procedure to achieve this small reset of the key light of your car.
  • Oil level issue: It is possible that the oil level sensor is suggesting that the oil level is too low.
  • EGR Valve: Another opportunity is that the key light on your BENTLEY CONTINENTAL is on because your EGR valve is dirty, very often the case if you are driving short distances or not pushing the gears of your car.
  • Glow plugs: Finally, the last and most general cause of an orange wrench light on BENTLEY CONTINENTAL is that your glow plugs are getting tired.

What if the orange key light on BENTLEY CONTINENTAL is on?

We are now going to proceed to the second component of our article and try to present you the solutions to each of the problems pointed out in the previous part and therefore how to proceed if I discover the wrench light on your BENTLEY CONTINENTAL ? To achieve this, we will take turns answering each of the problems you may possibly face:

  • Reset the drain indicator light: As we mentioned earlier in this article, a very easy reset of the indicator light on your BENTLEY CONTINENTAL will be enough to turn off the key indicator and restart it for a cycle of 10 000km or 1 year, see our article to conduct this operation.
  • Oil level issue: This is a very basic issue and the easiest to solve. You will simply have to check your oil level, we recommend you to take the opportunity to verify all your oil levels.
  • EGR Valve: In the case of a light that comes on because of the EGR valve, you will need to have the points of this fault code through the diagnostic tool. Once you are sure of the source of the issue, you can try to clean your car by pushing the gears (hot engine), otherwise disassemble and clean the EGR valve of your BENTLEY CONTINENTAL , we made a tutorial to help you to do it. In any other case, go to a garage area and prepare to pay a few hundred euros.
  • Glow plugs: Finally, if your issue originates from your glow plugs, the procedure to change them is quite very easy and you won’t need more than 40 euros worth of glow plugs.

There, you now know everything about the wrench light on BENTLEY CONTINENTAL , we hope this article has helped you solve your issue.

If you want more guides on the BENTLEY CONTINENTAL , go to our BENTLEY CONTINENTAL category.