If you’re a bit of a do-it-yourselfer, you’re likely willing to handle the vast majority of the service to be completed on your skoda yeti, but some are more difficult than others and necessitate the removal of body parts or parts to access the component you want to focus on. We want to help you in this task. That’s why in this article we are going to find out how to remove the bumper from a skoda yeti. This process is not very difficult and you should be able to do it with few equipment. To do so , first we will see how to remove the front bumper of your skoda yeti, then how to remove the rear bumper of this one.
How to remove the front bumper from a skoda yeti
So let’s commence our document with the front bumper of your skoda yeti. To take it off, you will just require a set of ratchet wrenches, some screwdrivers and torx bits. Here are the steps you will have to follow in order to disassemble the bumper of your skoda yeti in good conditions:
- If you want to be more relaxed, we recommend you to lift your skoda yeti and to remove the front wheels to have a best access to the whole front bumper.
- Open the bonnet of your motor vehicle: Seems evident, but you will need to have access to the bumper attachment in your engine compartment.
- Take off the wheel arches: They’re also known as fenders, but they’ll get in the way and prevent you from accessing all the screws on the front bumper of your skoda yeti. Depending on your automobile features and the year of your model, you will also be able to find staples, to achieve this, you will just have to use a staple extractor or to do it carefully with a big flat screwdriver, and use a lever to open the staple.
- Then you will have to unscrew the screws that is at the rear of your mudguard and that fastens the front bumper of your skoda yeti on the sides.
- Unscrew the screws or remove the clips on the upper part of the bumper in the engine compartment.
- Now it’s time to go beneath your skoda yeti to unscrew the bolts that are on the chassis of the automobile, you will find some in the middle of the bumper and on the sides.
- Remember to disconnect the connection of the plate lighting and the distance control sensor if you have it.
- Carefully remove the front bumper by first unclipping the sides. If it doesn’t come off, you probably forgot a screw or a clip. Think of employing a carpet or other to avoid that it gets scratched by touching the ground.
That’s it, you’ve seen all the steps of how to remove the front bumper from your skoda yeti, to reassemble it follow the steps in the opposite way.
How to remove the rear bumper from a skoda yeti
And to conclude, whether or not the operation is quite similar, we will look at the case of removing the rear bumper from your skoda yeti. For each step to avoid repeating ourselves we will just give you the broad outlines, read the part 1 if you have any uncertainties or questions for more information.
- Start by executing the same first step, that is, lift your skoda yeti and take off your rear wheels in order to have an optimal working space to remove the bumper of your skoda yeti without trouble
- Remove the rear wheel arches of your skoda yeti to access the side bumper side brackets
- Open your trunk
- Take off the side brackets in your wheel arches to make it more convenient to remove the bumper from your skoda yeti.
- Take away the lower bindings underneath your skoda yeti.
- At the same time, make sure to disconnect the rear license plate light and the reverse radar sensors if you are equipped with them.
- Unscrew the top brackets from the top of the trunk.
- Now all you have to do is remove the rear bumper from your skoda yeti, follow the same process as for the front bumper
Here, you have discoverd through these two parts, how to remove the bumper from a skoda yeti whether it is the front one or the rear one the solutions are essentially the same and it is enough to be careful to make everything go well.
To find more tips on the skoda yeti, take a look at the skoda yeti category.
