You’re uninterested in listening to cassettes and only being able to enjoy the radio, while your phone is full of your preferred music but you don’t have a jack or usb port on your car radio, so you can’t enjoy your car trips to the fullest… That’s precisely why we’ve posted this content to help you, because in this article you’re going to find out how to install a car radio on your Chrysler Town & Country. To accomplish this, first we will see how to remove the old car radio, then how to install a car radio on Chrysler Town & Country and to finish, how to connect it.
How to install car radio on Chrysler Town & Country: Removing the old car stereo
Before we get down to the serious business of how to install a car stereo on your Chrysler Town & Country, there is one essential step, take out the audio set you already have on your car. There are two scenarios, either you have an original headunit, or you have an universal set. Before you start taking out, always make sure to remove the negative wire from the battery to prevent any risk of short-circuit or electrocution. Once this is conducted, here are the two ways dependant upon the stereo that equips your Chrysler Town & Country:
- Original car radio:
In cases like this, you’ll have to be patient, generally, the simple use of extracting clamps in the 4 holes in the corners of the car radio should be enough to remove it. But on some specific models of specific years, this process will not be enough to remove the old car radio from your Chrysler Town & Country. Actually, you will need to remove certain parts of the centre console to access the car radio itself. To get this done, you will need to use a screwdriver to remove the plastic covers that are in the way. Once you have access to the station, make sure to disconnect all the connections. - Aftermarket radio :
In this circumstance the procedure is easier, you will just have to use the extracting clamps and press on the 4 corners of your station to make it come out of its place. Once this step is conducted, make sure to unplug it and remove the metal frame that supports it in the notch of the center console. That’s it, you’ve finished dismantling your old car radio, all you have to do is install the new one!
How to install car radio on your Chrysler Town & Country: Fitting and connecting the car radio
Let’s go to the essential part for you, how to install a car stereo on your Chrysler Town & Country. Beforehand, take the time to verify the suitability of your car and your headunit, and to read the installation information, which may give you specific guidelines.
Here are the various guidelines involved in installing an aftermarket car radio. First of all, put in place the metal frame supplied with your new car radio, this frame has the function of holding your car radio in place on your Chrysler Town & Country, once placed, make sure to press the locking tabs on each side of the frame. Once this step has been carried out, you will need to connect the three plugs of your car radio, two ISO connectors for power supply and sound transfer to the speakers of your Chrysler Town & Country, then the radio antenna socket. For the latter, on some models you may need an adapter to transform it from male to female to be able to adapt it to the socket of your new radio. Finally, all you have to do is push your car radio into the metal frame, snap it into place, and position the plastic or metal frame supplied with it on its contour. That’s it, you’ve just learned how to install a car radio on Chrysler Town & Country, make sure to check that the radio is switched on, that the sound is working and that you’re picking up the radio and you’re ready to enjoy your new car radio. If you have other complications, or want to learn more about your car, don’t be reluctant to visit our page dedicated to it.
To get more tips on the Chrysler Town & Country, take a look at the Chrysler Town & Country category.
