Some routine service actions such as changing the engine unit oil might seem obvious and very important, while others such as changing the gearbox oil from its Acura RDX may seem less automatic. However, make no mistake, changing the gearbox is just as important as changing the engine unit oil. This content will show you the purpose of the gearbox oil, then, why it is vital to replace the gearbox of your Acura RDX, and at last, how to replace the gearbox oil of a Acura RDX .
Function of gearbox oil on a Acura RDX
So we start our content with the purpose of gearbox oil on a Acura RDX. The objective of this short introduction is to make you understand the benefit of this fluid which guarantees the good working of your motor vehicle. The gearbox of your car has the objective to demultiply the power transferred by the engine unit and send it back to your wheels . It is made up of pinions and gears that will allow the wheels to rotate at different speeds depending on the curves and the gear engaged. It will function with the help of an axle and a differential. All these parts will need to be firmly lubricate to objective properly, limit friction and tolerate the high temperatures built by the engine unit and friction. Your transmission oil has a high viscosity and will prevent the formation of filings or gear breakage, so it is necessary to the proper working of the gearbox.
Why replacing the gearbox oil from a Acura RDX?
Now we’ll see what’s the point of draining the gearbox oil of your Acura RDX?
Benefit of gearbox oil changing Acura RDX
There are several concerns to replace the gearbox of your motor vehicle repeatedly, we will list them and detail them below:
- After a while, the oil will lose its viscosity due to friction and temperature rise, which will cause less lubrication of the gears and pinions and therefore risk to break some of them.
- Same as viscosity, time and temperature rise will decrease the oil resistance to the engine unit temperature, So it will fluidize much more easily when the engine heats up, which is not good for your gearbox.
- Accumulation of metallic residues: Finally, even if you constantly have a quality oil, a gearbox is an component that wears out and creates iron filings with friction, the oil will pick them up and if it builds up too much these residues can get into gears and break them.
When to do the gearbox oil replace on a Acura RDX?
If you want to do an automatic or manual gearbox oil change on Acura RDX or strong> the process is not similar, nevertheless, dealers do not give mileage recommendations to replace the oil in your gearbox, however when you do an intervention on the gearbox it is wise to replace it, in any other case here are the factors to make you think about doing this oil replace.
Oil replace for manual gearbox Acura RDX
- Gears are jumping: you are most certainly missing oil and you may possibly have a gearbox oil leak, please see our content page on gearbox leaks on Acura RDX for more information.
- The gearbox cracks when you change gears: The oil has undoubtedly lost viscosity and is too fluid, so the gears get stuck.
- Difficulty to shift gears: Same issue as just before, the oil is certainly too fluid.
Automatic gearbox oil replace
- A slow start from the neutral position to the first one: often a viscosity issue.
- Difficulty or even impossibility to shift gears: Lack of oil
.
How to replace gearbox oil of a Acura RDX?
At last, to finish this content page, we will show you you how to empty the gearbox oil of your Acura RDX , it’s less difficult than you might presume, here are the few guidelines to follow to do it properly:
- Heat your Acura RDX for about 10 minutes to get a fluid oil, place it flat on 4 stands.
- Install a drain pan under the drain plug, open it, and clean it well because it will most certainly gather filings.
- Let all the oil run out until it’s all gone.
- Change and tighten the cap, then fill with a syringe through the filler cap with the manufacturer’s recommended dose
If you need more guides on the Acura RDX, go to our Acura RDX category.
