You’re tired of listening to cassettes and only having the capability to enjoy the radio, while your phone is loaded with your favourite tracks but you don’t have a jack or usb port on your car radio, so you can’t enjoy your car travels to the fullest… That’s precisely why we’ve written and published this content page to help you, because in this article you’re going to learn about how to install a car radio on your Chevrolet Trax. To get this done, first we will find out how to remove the old car radio, then how to install a car radio on Chevrolet Trax and finally, how to connect it.
How to install car radio on Chevrolet Trax: Removing the old car stereo
Before we start the serious business of how to install a car stereo on your Chevrolet Trax, there is one essential task, take away the audio set you currently have on your car. There are two situations, either you have an original headunit, or you have an universal set. Before you start dismantling, always remember to remove the negative wire from the battery to prevent any risk of short-circuit or electrocution. Once this is achieved, here are the two solutions dependant upon the stereo that equips your Chevrolet Trax:
- Original car radio:
In this instance, you’ll have to be patient, in most cases, the simple use of extracting clamps in the 4 holes in the corners of the car radio should be enough to remove it. But on some particular models of specific years, this process will not be enough to remove the old car radio from your Chevrolet Trax. In actual fact, you will need to remove certain auto parts of the centre console to access the car radio itself. To get this done, you will need to use a screwdriver to remove the plastic covers that are in the way. Once you have access to the station, remember to disconnect all the connections. - Aftermarket radio :
In this situation the procedure is less difficult, you will just have to use the extracting clamps and press on the 4 corners of your station to make it come out of its place. Once this step is achieved, remember to unplug it and remove the metal frame that supports it in the notch of the center console. That’s it, you’ve completed dismantling your old car radio, all you have to do is install the new one!
How to install car radio on your Chevrolet Trax: Fitting and connecting the car radio
Let’s go to the most important step for you, how to install a car stereo on your Chevrolet Trax. Ahead of time, spend some time to examine the compatibility of your car and your headunit, and to read the installation instructions, which may give you specific recommendations.
Here are the various guidelines required in installing an aftermarket car radio. Firstly, put in place the metal frame supplied with your new car radio, this frame has the job of holding your car radio in place on your Chevrolet Trax, once positioned, remember to press the locking tabs on each side of the frame. Once this step has been finished, you will need to connect the three plugs of your car radio, two ISO connectors for power supply and sound transfer to the speakers of your Chevrolet Trax, then the radio antenna socket. For the latter, on some models you may need an adapter to transform it from male to female in order to adapt it to the socket of your new radio. Finally, all you have to do is push your car radio into the metal frame, snap it into place, and position the plastic or metal frame supplied with it on its contour. That’s it, you’ve just discovered how to install a car radio on Chevrolet Trax, remember to check that the radio is switched on, that the sound is working and that you’re picking up the radio and you’re ready to enjoy your new car radio. If you have other concerns, or want to learn more about your car, don’t hesitate to visit our page dedicated to it.
To get more tips on the Chevrolet Trax, take a look at the Chevrolet Trax category.
