When your car is running normally everything is fine, however if it begins to have regular problems you may begin to wonder, especially if your car won’t start. In this post we will teach you where the starter of a Toyota Yaris 3 is, it will help you to fix your ignition problems. To do this, we will first explain the function of a starter, then, where is the starter on a Toyota Yaris 3 , and, at last, how to replace the starter of a car.

find-starter-toyota-yaris-3

Function of the starter on your Toyota Yaris 3

We begin this content page by explaining the function of the starter motor on your Toyota Yaris 3. The starter is an electric motor which is powered by your battery, its job will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is consisting of three main parts:

  • The Solenoid: This component is an electrical relay that will act as a switch, it will be activated by the key of your Toyota Yaris 3 and let the current from your battery to the engine of your alternator.

    • The engine: Main component of your alternator, it is the one that will drive the flywheel of your Toyota Yaris 3 and make enough speed for your engine to begin.

  • The engagement pinion: This is the last part of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it allows to transmit the force from the starter to the engine.

Where is the starter on a Toyota Yaris 3?

Now that we have fairly quickly explained what a starter is and how it works, we will answer the question that most of you have to ask yourselves where is the starter based on a Toyota Yaris 3? It is quite easy to locate a starter, in truth, it is a large part that will almost always be positioned in a similar place. We let you see the two possible locations for your car starter below.

Location of the starter on traditional Toyota Yaris 3

First and most common case, where to locate the starter of a Toyota Yaris 3 with a conventional motor (implied without start and stop). The starter has a specific objective, to start the engine of your car, for that, it must always be near the engine flywheel of this one because it is the part that it actuates when it is used. The flywheel is based at the junction between your gearbox and your engine.

Location of the starter to Toyota Yaris 3 with start and stop

And now second possible starter location of your Toyota Yaris 3 . This case is much less frequent. It only concerns engines built with start and stop, and a good part of them will be equipped with a starter positioned close to the flywheel. Nevertheless, on some specific series or engines, the starter of your Toyota Yaris 3 may be included in your alternator, it is then named a starter-alternator, to locate it nothing easier, find your accessory belt and you should see the big starter block.

How to replace the starter on a Toyota Yaris 3?

Finally, we’ll describe to you quite fairly quickly how to replace the starter of a Toyota Yaris 3. This procedure is not necessarily complex, it can be considered by people who have a lowest of basic mechanical knowledge and adapted equipment. Stick to below the main steps to perform this intervention:

  • Disconnect the battery on your Toyota Yaris 3, if you don’t know how to do it, don’t hesitate to seek advice from our content page which explains how to do it without taking any risk.
  • After locating your starter, loosen the fasteners that hold it in your engine block, there will usually be 2 or 3

    • .

  • It will be time to disconnect the power cables from the starter motor of your Toyota Yaris 3, however before doing so we recommend you to take a picture of the set up to avoid making a mistake when reassembling.
  • It’s possible that to take out it you may need to take out parts like the gimbal.
  • Remount the new starter, being careful when connecting the connectors.
  • Reconnect your battery and test your starter.

To discover more tips on the Toyota Yaris 3, take a look at the Toyota Yaris 3 category.