When your car is running normally everything is fine, however if it begins to have frequent problems you might begin to wonder, especially if your car won’t start. In this post we will learn you where the starter of a Toyota C-hr is, it will help you to resolve your ignition problems. To get this done, we will first explain the function of a starter, then, where is the starter on a Toyota C-hr , and, at last, how to replace the starter of a car.

find-starter-toyota-c-hr

Function of the starter on your Toyota C-hr

We begin this article by explaining the function of the starter motor on your Toyota C-hr. The starter is an electric motor which is powered by your battery, its role will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is composed of three main parts:

  • The Solenoid: This component is an electrical relay that will action as a switch, it will be activated by the key of your Toyota C-hr and let the current from your battery to the engine of your alternator.

    • The engine: Main component of your alternator, it is the one that will drive the flywheel of your Toyota C-hr and bring about enough speed for your engine to begin.

  • The engagement pinion: This is the last part of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it enables to send the force from the starter to the engine.

Where is the starter on a Toyota C-hr?

Now that we have quickly detailed what a starter is and how it functions, we will answer the question that most of you have to ask yourselves where is the starter located on a Toyota C-hr? It is quite easy to find a starter, in actual fact, it is a large part that will almost always be placed in a similar place. We let you discover the two possible locations for your car starter down below.

Location of the starter on classic Toyota C-hr

First and most general case, where to find the starter of a Toyota C-hr with a conventional motor (implied without start and stop). The starter has a particular action, to start the engine of your car, for that, it must always be near the engine flywheel of this one because it is the part that it actuates when it is used. The flywheel is located at the junction between your gearbox and your engine.

Location of the starter to Toyota C-hr with start and stop

And now second possible starter location of your Toyota C-hr . This case is much less frequent. It just is about engines built with start and stop, and a good part of them will be equipped with a starter placed close to the flywheel. However, on some particular series or engines, the starter of your Toyota C-hr may be integrated in your alternator, it is then named a starter-alternator, to find it nothing less difficult, find your accessory belt and you should see the big starter block.

How to replace the starter on a Toyota C-hr?

Finally, we’ll describe to you actually quite quickly how to replace the starter of a Toyota C-hr. This process is not actually complex, it can be considered by people who have a minimum of simple mechanical expertise and adapted equipment. Stick to down below the main steps to perform this intervention:

  • Disconnect the battery on your Toyota C-hr, if you don’t know how to do it, don’t think twice to consult our article which details how to do it without taking any risk.
  • After locating your starter, loosen the fasteners that hold it in your engine block, there will in most cases be 2 or 3

    • .

  • It will be time to disconnect the power cables from the starter motor of your Toyota C-hr, however before doing so we suggest you to take a picture of the installation to avoid making a mistake when reassembling.
  • It’s possible that to take out it you might need to take out auto parts like the gimbal.
  • Remount the new starter, being careful when connecting the connectors.
  • Reconnect your battery and test your starter.

If perhaps you have any additional questions about the Toyota C-hr, do not hesitate to consult our Toyota C-hr category.