When your car is running normally everything is fine, nevertheless if it begins to have regular problems you may possibly begin to question, especially if your motor vehicle won’t start. In this post we will teach you where the starter of a Subaru Outback is, it will help you to solve your ignition problems. To achieve this, we will first summarize the role of a starter, then, where is the starter on a Subaru Outback , and, finally, how to change the starter of a motor vehicle.
Purpose of the starter on your Subaru Outback
We begin this content by detailing the role of the starter motor on your Subaru Outback. The starter is an electric motor which is powered by your battery, its function will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is consisting of three most important parts:
- The Solenoid: This component is an electrical relay that will action as a switch, it will be activated by the key of your Subaru Outback and let the current from your battery to the engine of your alternator.
- The engagement pinion: This is the last part of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it enables to transfer the force from the starter to the engine.
The engine: Main element of your alternator, it is the one that will drive the flywheel of your Subaru Outback and make enough speed for your engine to begin.
Where is the starter on a Subaru Outback?
Now that we have fairly quickly described what a starter is and how it functions, we will answer the question that most of you have to ask yourselves where is the starter found on a Subaru Outback? It is quite easy to discover a starter, obviously, it is a large part that will almost always be situated in a similar place. We let you discover the two possible spots for your motor vehicle starter below.
Location of the starter on traditional Subaru Outback
First and most basic circumstance, where to discover the starter of a Subaru Outback with a conventional motor (implied without start and stop). The starter has a specific objective, to start the engine of your motor vehicle, for that, it must always be near the engine flywheel of this one because it is the part that it actuates when it is used. The flywheel is found at the junction between your gearbox and your engine.
Location of the starter to Subaru Outback with start and stop
And now second possible starter location of your Subaru Outback . This case is much less frequent. It only is about engines built with start and stop, and a good part of them will be equipped with a starter situated close to the flywheel. However, on some specific series or engines, the starter of your Subaru Outback may be integrated in your alternator, it is then called a starter-alternator, to discover it nothing easier, identify your accessory belt and you should find out the big starter block.
How to change the starter on a Subaru Outback?
Finally, we’ll show you to you actually quite fairly quickly how to change the starter of a Subaru Outback. This process is not necessarily complex, it can be considered by people who have a lowest of simple mechanical experience and adapted equipment. Follow below the most important steps to carry out this intervention:
- Disconnect the battery on your Subaru Outback, if you don’t know how to do it, don’t think twice to consult our content which points out how to do it without taking any risk.
- After locating your starter, loosen the fasteners that hold it in your engine block, there will usually be 2 or 3
- It will be time to disconnect the power cables from the starter motor of your Subaru Outback, nevertheless before doing so we recommend you to take a picture of the set up to avoid making a mistake when reassembling.
- It’s possible that to remove it you may possibly need to remove parts like the gimbal.
- Remount the new starter, being careful when connecting the connectors.
- Reconnect your battery and test your starter.
.
To find more tips on the Subaru Outback, take a look at the Subaru Outback category.
