When your car is running normally everything is fine, nevertheless if it begins to have frequent problems you may possibly start to question, specifically if your car won’t start. In this post we will show you where the starter of a Nissan Pulsar is, it will help you to fix your ignition problems. To do this, we will first illustrate the function of a starter, then, where is the starter on a Nissan Pulsar , and, finally, how to change the starter of a car.
Function of the starter on your Nissan Pulsar
We start this content page by detailing the function of the starter motor on your Nissan Pulsar. The starter is an electric motor which is powered by your battery, its job will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is consisting of three main parts:
- The Solenoid: This part is an electrical relay that will action as a switch, it will be activated by the key of your Nissan Pulsar and let the current from your battery to the engine of your alternator.
- The engagement pinion: This is the last component of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it enables to send the force from the starter to the engine.
The engine: Most important component of your alternator, it is the one that will drive the flywheel of your Nissan Pulsar and make enough speed for your engine to start.
Where is the starter on a Nissan Pulsar?
Now that we have fairly quickly described what a starter is and how it functions, we will answer the question that most of you have to ask yourselves where is the starter found on a Nissan Pulsar? It is quite easy to locate a starter, in actual fact, it is a large component that will almost always be positioned in a similar place. We let you see the two possible places for your car starter down below.
Location of the starter on traditional Nissan Pulsar
First and most common case, where to locate the starter of a Nissan Pulsar with a conventional motor (implied without start and stop). The starter has a specific function, to start the engine of your car, for that, it must always be near the engine flywheel of this one because it is the component that it actuates when it is used. The flywheel is found at the junction between your gearbox and your engine.
Location of the starter to Nissan Pulsar with start and stop
And now second possible starter location of your Nissan Pulsar . This case is much less frequent. It only is about engines equipped with start and stop, and a good component of them will be equipped with a starter positioned close to the flywheel. Nevertheless, on some specific series or engines, the starter of your Nissan Pulsar may be included in your alternator, it is then called a starter-alternator, to locate it nothing much easier, find your accessory belt and you should discover the big starter block.
How to change the starter on a Nissan Pulsar?
Finally, we’ll show you to you quite fairly quickly how to change the starter of a Nissan Pulsar. This procedure is not necessarily difficult, it can be considered by people who have a minimal of simple mechanical knowledge and adapted tools. Follow down below the main steps to carry out this intervention:
- Disconnect the battery on your Nissan Pulsar, if you don’t know how to do it, don’t hesitate to consult our content page which explains how to do it without taking any risk.
- After finding your starter, loosen the fasteners that hold it in your engine block, there will generally be 2 or 3
- It will be time to disconnect the power cables from the starter motor of your Nissan Pulsar, nevertheless before doing so we recommend you to take a picture of the installation to avoid making a mistake when reassembling.
- It’s possible that to take out it you may possibly need to take out auto parts like the gimbal.
- Remount the new starter, being careful when connecting the connectors.
- Reconnect your battery and test your starter.
.
To get more tips on the Nissan Pulsar, take a look at the Nissan Pulsar category.
