When your car is running normally everything is fine, nevertheless if it starts to have frequent problems you may possibly start to wonder, specifically if your motor vehicle won’t start. In this post we will learn you where the starter of a Nissan Patrol 3 is, it will help you to resolve your ignition problems. To do this, we will first describe the role of a starter, then, where is the starter on a Nissan Patrol 3 , and, finally, how to change the starter of a motor vehicle.
Purpose of the starter on your Nissan Patrol 3
We start this content page by detailing the role of the starter motor on your Nissan Patrol 3. The starter is an electric motor which is powered by your battery, its job will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is made up of three most important parts:
- The Solenoid: This part is an electrical relay that will action as a switch, it will be activated by the key of your Nissan Patrol 3 and let the current from your battery to the engine of your alternator.
- The engagement pinion: This is the last part of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it allows to send the force from the starter to the engine.
The engine: Main component of your alternator, it is the one that will drive the flywheel of your Nissan Patrol 3 and generate enough speed for your engine to start.
Where is the starter on a Nissan Patrol 3?
Now that we have quickly described what a starter is and how it functions, we will answer the question that most of you have to ask yourselves where is the starter based on a Nissan Patrol 3? It is quite easy to locate a starter, in fact, it is a large part that will almost constantly be positioned in a similar location. We let you discover the two possible places for your motor vehicle starter below.
Location of the starter on traditional Nissan Patrol 3
First and most basic circumstance, where to locate the starter of a Nissan Patrol 3 with a conventional motor (implied without start and stop). The starter has a particular objective, to start the engine of your motor vehicle, for that, it must constantly be near the engine flywheel of this one because it is the part that it actuates when it is used. The flywheel is based at the junction between your gearbox and your engine.
Location of the starter to Nissan Patrol 3 with start and stop
And now second possible starter location of your Nissan Patrol 3 . This case is much less frequent. It only is about engines built with start and stop, and a good part of them will be equipped with a starter positioned close to the flywheel. However, on some particular series or engines, the starter of your Nissan Patrol 3 might be included in your alternator, it is then called a starter-alternator, to locate it nothing easier, find your accessory belt and you should see the big starter block.
How to change the starter on a Nissan Patrol 3?
Finally, we’ll show you to you quite quickly how to change the starter of a Nissan Patrol 3. This procedure is not necessarily difficult, it can be considered by people who have a minimal of simple mechanical expertise and adapted tools. Stick to below the most important steps to perform this intervention:
- Disconnect the battery on your Nissan Patrol 3, if you don’t know how to do it, don’t hesitate to consult our content page which explains how to do it without taking any risk.
- After discovering your starter, loosen the fasteners that hold it in your engine block, there will generally be 2 or 3
- It will be time to disconnect the power cables from the starter motor of your Nissan Patrol 3, nevertheless before doing so we advise you to take a picture of the installation to avoid making a mistake when reassembling.
- It’s possible that to take out it you may possibly need to take out parts like the gimbal.
- Remount the new starter, being careful when connecting the connectors.
- Reconnect your battery and test your starter.
.
If you need more guides on the Nissan Patrol 3, go to our Nissan Patrol 3 category.
