When your car is running normally everything is fine, nevertheless if it begins to have frequent problems you may start to wonder, specifically if your motor vehicle won’t start. In this post we will learn you where the starter of a Mazda 6 is, it will help you to solve your ignition problems. To achieve this, we will first describe the function of a starter, then, where is the starter on a Mazda 6 , and, at last, how to replace the starter of a motor vehicle.

find-starter-mazda-6

Purpose of the starter on your Mazda 6

We start this article by detailing the function of the starter motor on your Mazda 6. The starter is an electric motor which is powered by your battery, its function will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is built from three main parts:

  • The Solenoid: This part is an electrical relay that will act as a switch, it will be activated by the key of your Mazda 6 and let the current from your battery to the engine of your alternator.

    • The engine: Main component of your alternator, it is the one that will drive the flywheel of your Mazda 6 and make enough speed for your engine to start.

  • The engagement pinion: This is the last component of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it enables to send the force from the starter to the engine.

Where is the starter on a Mazda 6?

Now that we have quickly explained what a starter is and how it functions, we will answer the question that most of you have to ask yourselves where is the starter found on a Mazda 6? It is quite easy to locate a starter, in actual fact, it is a large component that will almost always be placed in a similar place. We let you discover the two possible places for your motor vehicle starter below.

Location of the starter on classic Mazda 6

First and most basic case, where to locate the starter of a Mazda 6 with a conventional motor (implied without start and stop). The starter has a particular action, to start the engine of your motor vehicle, for that, it must always be near the engine flywheel of this one because it is the component that it actuates when it is used. The flywheel is found at the junction between your gearbox and your engine.

Location of the starter to Mazda 6 with start and stop

And now second possible starter location of your Mazda 6 . This case is much less frequent. It just concerns engines equipped with start and stop, and a good component of them will be equipped with a starter placed close to the flywheel. Nevertheless, on some particular series or engines, the starter of your Mazda 6 may be integrated in your alternator, it is then known as a starter-alternator, to locate it nothing easier, find your accessory belt and you should discover the big starter block.

How to replace the starter on a Mazda 6?

Finally, we’ll describe to you actually quite quickly how to replace the starter of a Mazda 6. This procedure is not necessarily difficult, it can be considered by people who have a minimum of basic mechanical experience and adapted equipment. Follow below the main steps to carry out this intervention:

  • Disconnect the battery on your Mazda 6, if you don’t know how to do it, don’t think twice to consult our article which explains how to do it without taking any risk.
  • After finding your starter, loosen the fasteners that hold it in your engine block, there will usually be 2 or 3

    • .

  • It will be time to disconnect the power cables from the starter motor of your Mazda 6, nevertheless before doing so we advise you to take a picture of the set up to avoid making a mistake when reassembling.
  • It’s possible that to remove it you may need to remove auto parts like the gimbal.
  • Remount the new starter, being careful when connecting the connectors.
  • Reconnect your battery and test your starter.

If you have any additional questions about the Mazda 6, do not hesitate to consult our Mazda 6 category.