When your car is running normally everything is fine, however if it begins to have regular complications you may possibly start to speculate, specifically if your car won’t start. In this article we will show you where the starter of a hyundai i10 is, it will help you to solve your ignition complications. To achieve this, we will first summarize the purpose of a starter, then, where is the starter on a hyundai i10 , and, finally, how to change the starter of a car.

find-starter-hyundai-i10

Function of the starter on your hyundai i10

We start this article by detailing the purpose of the starter motor on your hyundai i10. The starter is an electric motor which is powered by your battery, its purpose will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is composed of three most important parts:

  • The Solenoid: This part is an electrical relay that will work as a switch, it will be activated by the key of your hyundai i10 and let the current from your battery to the engine of your alternator.

    • The engine: Main component of your alternator, it is the one that will drive the flywheel of your hyundai i10 and make enough speed for your engine to start.

  • The engagement pinion: This is the last part of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it allows to send the force from the starter to the engine.

Where is the starter on a hyundai i10?

Now that we have quickly detailed what a starter is and how it works, we will answer the question that most of you have to ask yourselves where is the starter located on a hyundai i10? It is quite easy to locate a starter, in fact, it is a large part that will almost constantly be situated in a similar location. We let you see the two possible locations for your car starter down below.

Location of the starter on classic hyundai i10

First and most basic circumstance, where to locate the starter of a hyundai i10 with a conventional motor (implied without start and stop). The starter has a specific action, to start the engine of your car, for that, it must constantly be near the engine flywheel of this one because it is the part that it actuates when it is used. The flywheel is located at the junction between your gearbox and your engine.

Location of the starter to hyundai i10 with start and stop

And now second possible starter location of your hyundai i10 . This case is much less frequent. It just concerns engines fitted with start and stop, and a good part of them will be equipped with a starter situated close to the flywheel. Nevertheless, on some specific series or engines, the starter of your hyundai i10 might be included in your alternator, it is then known as a starter-alternator, to locate it nothing less difficult, locate your accessory belt and you should see the big starter block.

How to change the starter on a hyundai i10?

Finally, we’ll show you to you quite quickly how to change the starter of a hyundai i10. This procedure is not necessarily complex, it can be considered by people who have a lowest of simple mechanical knowledge and adapted tools. Follow down below the most important steps to carry out this intervention:

  • Disconnect the battery on your hyundai i10, if you don’t know how to do it, don’t hesitate to seek advice from our article which details how to do it without taking any risk.
  • After discovering your starter, loosen the fasteners that hold it in your engine block, there will generally be 2 or 3

    • .

  • It will be time to disconnect the power cables from the starter motor of your hyundai i10, however before doing so we recommend you to take a picture of the installation to avoid making a mistake when reassembling.
  • It’s possible that to take out it you may possibly need to take out parts like the gimbal.
  • Remount the new starter, being careful when connecting the connectors.
  • Reconnect your battery and test your starter.

If you need more guides on the hyundai i10, go to our hyundai i10 category.