When your car is running normally everything is fine, nevertheless if it begins to have regular complications you might start to wonder, specifically if your motor vehicle won’t start. In this post we will learn you where the starter of a GMC Savana is, it will help you to solve your ignition complications. To achieve this, we will first describe the purpose of a starter, then, where is the starter on a GMC Savana , and, at last, how to change the starter of a motor vehicle.


Purpose of the starter on your GMC Savana

We start this article by explaining the purpose of the starter motor on your GMC Savana. The starter is an electric motor which is powered by your battery, its purpose will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is composed of three main parts:

  • The Solenoid: This component is an electrical relay that will work as a switch, it will be activated by the key of your GMC Savana and let the current from your battery to the engine of your alternator.
  • The engine: Main element of your alternator, it is the one that will drive the flywheel of your GMC Savana and bring about enough speed for your engine to start.

  • The engagement pinion: This is the last component of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it allows to transmit the force from the starter to the engine.

Where is the starter on a GMC Savana?

Now that we have quickly explained what a starter is and how it functions, we will answer the question that most of you have to ask yourselves where is the starter found on a GMC Savana? It is quite easy to find a starter, in truth, it is a large component that will almost always be placed in a similar location. We let you see the two possible spots for your motor vehicle starter below.

Location of the starter on traditional GMC Savana

First and most general circumstance, where to find the starter of a GMC Savana with a conventional motor (implied without start and stop). The starter has a specific objective, to start the engine of your motor vehicle, for that, it must always be near the engine flywheel of this one because it is the component that it actuates when it is used. The flywheel is found at the junction between your gearbox and your engine.

Location of the starter to GMC Savana with start and stop

And now second possible starter location of your GMC Savana . This case is much less frequent. It only is about engines fitted with start and stop, and a good component of them will be equipped with a starter placed close to the flywheel. Nevertheless, on some specific series or engines, the starter of your GMC Savana may be included in your alternator, it is then known as a starter-alternator, to find it nothing less difficult, identify your accessory belt and you should see the big starter block.

How to change the starter on a GMC Savana?

Finally, we’ll explain to you actually quite quickly how to change the starter of a GMC Savana. This procedure is not necessarily complex, it can be considered by people who have a minimal of simple mechanical knowledge and adapted equipment. Adhere to below the main steps to perform this intervention:

  • Disconnect the battery on your GMC Savana, if you don’t know how to do it, don’t think twice to consult our article which points out how to do it without taking any risk.
  • After discovering your starter, loosen the fasteners that hold it in your engine block, there will in most cases be 2 or 3
  • .

  • It will be time to disconnect the power cables from the starter motor of your GMC Savana, nevertheless before doing so we advise you to take a picture of the set up to avoid making a mistake when reassembling.
  • It’s possible that to take out it you might need to take out auto parts like the gimbal.
  • Remount the new starter, being careful when connecting the connectors.
  • Reconnect your battery and test your starter.

If perhaps you have any additional questions about the GMC Savana, do not hesitate to consult our GMC Savana category.