When your car is running normally everything is fine, however if it begins to have frequent complications you might start to question, especially if your motor vehicle won’t start. In this article we will teach you where the starter of a Ford Fusion is, it will help you to resolve your ignition complications. To achieve this, we will first illustrate the role of a starter, then, where is the starter on a Ford Fusion , and, at last, how to replace the starter of a motor vehicle.

find-starter-ford-fusion

Function of the starter on your Ford Fusion

We start this article by detailing the role of the starter motor on your Ford Fusion. The starter is an electric motor which is powered by your battery, its role will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is composed of three main parts:

  • The Solenoid: This component is an electrical relay that will work as a switch, it will be activated by the key of your Ford Fusion and let the current from your battery to the engine of your alternator.

    • The engine: Most important component of your alternator, it is the one that will drive the flywheel of your Ford Fusion and bring about enough speed for your engine to start.

  • The engagement pinion: This is the last part of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it allows to transfer the force from the starter to the engine.

Where is the starter on a Ford Fusion?

Now that we have quickly described what a starter is and how it functions, we will answer the question that most of you have to ask yourselves where is the starter found on a Ford Fusion? It is quite easy to locate a starter, in actual fact, it is a large part that will almost constantly be situated in a similar location. We let you discover the two possible locations for your motor vehicle starter down below.

Location of the starter on traditional Ford Fusion

First and most general case, where to locate the starter of a Ford Fusion with a conventional motor (implied without start and stop). The starter has a specific action, to start the engine of your motor vehicle, for that, it must constantly be near the engine flywheel of this one because it is the part that it actuates when it is used. The flywheel is found at the junction between your gearbox and your engine.

Location of the starter to Ford Fusion with start and stop

And now second possible starter location of your Ford Fusion . This case is much less frequent. It just concerns engines built with start and stop, and a good part of them will be equipped with a starter situated close to the flywheel. Nevertheless, on some specific series or engines, the starter of your Ford Fusion might be built in in your alternator, it is then known as a starter-alternator, to locate it nothing easier, identify your accessory belt and you should see the big starter block.

How to replace the starter on a Ford Fusion?

Finally, we’ll explain to you quite quickly how to replace the starter of a Ford Fusion. This process is not necessarily difficult, it can be considered by people who have a minimum of basic mechanical knowledge and adapted tools. Stick to down below the main steps to perform this intervention:

  • Disconnect the battery on your Ford Fusion, if you don’t know how to do it, don’t hesitate to consult our article which points out how to do it without taking any risk.
  • After discovering your starter, loosen the fasteners that hold it in your engine block, there will in most cases be 2 or 3

    • .

  • It will be time to disconnect the power cables from the starter motor of your Ford Fusion, however before doing so we advise you to take a picture of the set up to avoid making a mistake when reassembling.
  • It’s possible that to take out it you might need to take out parts like the gimbal.
  • Remount the new starter, being careful when connecting the connectors.
  • Reconnect your battery and test your starter.

If you wish more tutorials on the Ford Fusion, go to our Ford Fusion category.