When your car is running normally everything is fine, nevertheless if it begins to have regular problems you might start to wonder, specifically if your motor vehicle won’t start. In this post we will teach you where the starter of a Audi Tt is, it will help you to solve your ignition problems. To get this done, we will first illustrate the function of a starter, then, where is the starter on a Audi Tt , and, finally, how to change the starter of a motor vehicle.

find-starter-audi-tt

Function of the starter on your Audi Tt

We start this content by explaining the function of the starter motor on your Audi Tt. The starter is an electric motor which is powered by your battery, its purpose will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is consisting of three most important parts:

  • The Solenoid: This part is an electrical relay that will act as a switch, it will be activated by the key of your Audi Tt and let the current from your battery to the engine of your alternator.

    • The engine: Most important element of your alternator, it is the one that will drive the flywheel of your Audi Tt and make enough speed for your engine to start.

  • The engagement pinion: This is the last part of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it enables to send the force from the starter to the engine.

Where is the starter on a Audi Tt?

Now that we have fairly quickly described what a starter is and how it functions, we will answer the question that most of you have to ask yourselves where is the starter based on a Audi Tt? It is quite easy to locate a starter, indeed, it is a large part that will almost constantly be positioned in a similar place. We let you discover the two possible places for your motor vehicle starter down below.

Location of the starter on traditional Audi Tt

First and most common case, where to locate the starter of a Audi Tt with a conventional motor (implied without start and stop). The starter has a particular objective, to start the engine of your motor vehicle, for that, it must constantly be near the engine flywheel of this one because it is the part that it actuates when it is used. The flywheel is based at the junction between your gearbox and your engine.

Location of the starter to Audi Tt with start and stop

And now second possible starter location of your Audi Tt . This case is much less frequent. It just concerns engines equipped with start and stop, and a good part of them will be equipped with a starter positioned close to the flywheel. However, on some particular series or engines, the starter of your Audi Tt may be integrated in your alternator, it is then known as a starter-alternator, to locate it nothing easier, locate your accessory belt and you should discover the big starter block.

How to change the starter on a Audi Tt?

Finally, we’ll explain to you quite fairly quickly how to change the starter of a Audi Tt. This procedure is not actually complex, it can be considered by people who have a minimum of basic mechanical experience and adapted tools. Stick to down below the most important steps to carry out this intervention:

  • Disconnect the battery on your Audi Tt, if you don’t know how to do it, don’t think twice to consult our content which explains how to do it without taking any risk.
  • After locating your starter, loosen the fasteners that hold it in your engine block, there will usually be 2 or 3

    • .

  • It will be time to disconnect the power cables from the starter motor of your Audi Tt, nevertheless before doing so we advise you to take a picture of the set up to avoid making a mistake when reassembling.
  • It’s possible that to remove it you might need to remove auto parts like the gimbal.
  • Remount the new starter, being careful when connecting the connectors.
  • Reconnect your battery and test your starter.

If perhaps you have any additional questions about the Audi Tt, do not hesitate to consult our Audi Tt category.