When your car is running normally everything is fine, however if it begins to have frequent problems you may begin to wonder, specifically if your car won’t start. In this post we will show you where the starter of a Audi Q2 is, it will help you to resolve your ignition problems. To do this, we will first summarize the function of a starter, then, where is the starter on a Audi Q2 , and, finally, how to replace the starter of a car.

find-starter-audi-q2

Purpose of the starter on your Audi Q2

We begin this article by explaining the function of the starter motor on your Audi Q2. The starter is an electric motor which is powered by your battery, its role will be to make your engine run at a high enough speed to start it (usually around 300/400 rpm). It is built from three most important parts:

  • The Solenoid: This part is an electrical relay that will action as a switch, it will be activated by the key of your Audi Q2 and let the current from your battery to the engine unit of your alternator.

    • The engine unit: Main element of your alternator, it is the one that will drive the flywheel of your Audi Q2 and make enough speed for your engine unit to begin.

  • The engagement pinion: This is the last part of your starter, it is the toothed wheel that will be in direct contact with the flywheel, it allows to send the force from the starter to the engine.

Where is the starter on a Audi Q2?

Now that we have fairly quickly detailed what a starter is and how it works, we will answer the question that most of you have to ask yourselves where is the starter based on a Audi Q2? It is quite easy to discover a starter, in actual fact, it is a large part that will almost constantly be positioned in a similar location. We let you discover the two possible spots for your car starter down below.

Location of the starter on classic Audi Q2

First and most basic circumstance, where to discover the starter of a Audi Q2 with a conventional motor (implied without start and stop). The starter has a specific objective, to start the engine unit of your car, for that, it must constantly be near the engine unit flywheel of this one because it is the part that it actuates when it is used. The flywheel is based at the junction between your gearbox and your engine unit.

Location of the starter to Audi Q2 with start and stop

And now second possible starter location of your Audi Q2 . This case is much less frequent. It just is about engines built with start and stop, and a good part of them will be equipped with a starter positioned close to the flywheel. Nevertheless, on some specific series or engines, the starter of your Audi Q2 might be included in your alternator, it is then known as a starter-alternator, to discover it nothing much easier, identify your accessory belt and you should find out the big starter block.

How to replace the starter on a Audi Q2?

Finally, we’ll describe to you actually quite fairly quickly how to replace the starter of a Audi Q2. This process is not necessarily difficult, it can be considered by people who have a lowest of basic mechanical experience and adapted equipment. Adhere to down below the most important steps to perform this intervention:

  • Disconnect the battery on your Audi Q2, if you don’t know how to do it, don’t hesitate to seek advice from our article which details how to do it without taking any risk.
  • After discovering your starter, loosen the fasteners that hold it in your engine unit block, there will usually be 2 or 3

    • .

  • It will be time to disconnect the power cables from the starter motor of your Audi Q2, however before doing so we suggest you to take a picture of the installation to avoid making a mistake when reassembling.
  • It’s possible that to take out it you may need to take out parts like the gimbal.
  • Remount the new starter, being careful when connecting the connectors.
  • Reconnect your battery and test your starter.

If you want more guides on the Audi Q2, go to our Audi Q2 category.