The safety of a motor vehicle is important. Regardless if the Peugeot e-2008 are economic holes, certain routine service actions are essential. In this article we will explain to you when to change the brake discs of your Peugeot e-2008? To get this done, first of all, we will find out what the brake discs of your car are used for, then, when to change the brake discs of your Peugeot e-2008, and, finally, how to change them with new ones.

change-brake-discs-peugeot-e-2008

Benefit of the brake discs of a Peugeot e-2008

We start our article content by detailing what the brake discs of a Peugeot e-2008 are used for, it will allow you to understand why it is essential to make sure that they are always in good working order.
Brake discs are the main component of your braking system. In truth, braking on an Peugeot e-2008 is hydraulic, it is a system of hoses and pressurized oil that will come into action when you press your brake pedal. This pressure will actuate a piston that will push the brake pads on your brake disc which is mounted on your wheel. When the brake pads will pinch the discs which will trigger your Peugeot e-2008 to brake.

When to change the brake discs of a Peugeot e-2008?

We will now proceed to the section that undoubtedly attracts you to this content page, namely, when replacing the brake discs of a Peugeot e-2008? How we described it to you just before, the brake discs and pads work in osmosis, however these two components are wearing parts and they will, as time passes and especially the friction when braking wears out and loses braking power. We will now outline the different solutions to know when to change them:

  • We consider that in general the brake discs should be changed every 80, 000 – 100, 000 km on a Peugeot e-2008 , however it is essential to know that dependent on your driving style and the type of journey this can change significantly. Indeed, if you specifically drive on the motorway and your brakes are only slightly used, this value can increase, on the other hand, if you only drive in built-up areas, it can decrease.
  • A basic and successful technique to find out the state of the brake discs on your motor vehicle is during the technical inspection. Indeed this thorough control checks the state of your brakes and the controller will tell you if they are in good state or need to be changed.
  • A simple visual technique to know when to change the brake discs on your Peugeot e-2008 is to remove the wheels after the car has been set on stands. Once taken out, you will have the ability to access your discs and verify their state. If they have any big scratches or deformations you will have to change them. In any other case the second indicator to check is to measure the depth of the disk in relation to its edge, if this value exceeds 1 mm you will have to change them by new ones.

.

How to change the brake discs on your Peugeot e-2008?

Finally, to end this content page we will fairly quickly explain how to change the brake discs of your Peugeot e-2008. You must know that if you change the brake discs of your car, you will absolutely have to change the brake pads of your Peugeot e-2008, don’t think twice to seek advice from our content page which teaches you how to make this change.
As far as changing discs is concerned, here are the main steps to follow:

  • Put your Peugeot e-2008 on stands, take off the wheels you want to act on.
  • Using a large flat screwdriver, pry on your brake pads to compress the caliper piston as much as possible and have enough play to produce all your changes.
  • Using large Torx bits, remove the two nuts that lock the upper component of your brake caliper, remove it.
  • Take out your brake pads, then unlock your brake discs thanks to the two torx screws on the side of the disc, you might need a mallet to remove the discs.
  • Replace the discs and tighten them with the new torx screws provided, change your pads, reassemble the upper component of the caliper and tighten everything tightly.
  • Mounting your wheels, and make sure to do a 500-kilometer brake break-in before braking hard.

To get more tips on the Peugeot e-2008, take a look at the Peugeot e-2008 category.