The safety of a car is essential. Whether or not the Mazda 6 are financial holes, certain maintenance acts are vital. In this article we will explain to you when to change the brake discs of your Mazda 6? To accomplish this, first of all, we will discover what the brake discs of your motor vehicle are used for, then, when to change the brake discs of your Mazda 6, and, finally, how to change them with new ones.
Interest of the brake discs of a Mazda 6
We start our guideline by explaining what the brake discs of a Mazda 6 are used for, it will enable you to understand why it is essential to make sure that they are always in good functioning order.
Brake discs are the main component of your braking system. In fact, braking on an Mazda 6 is hydraulic, it is a system of hoses and pressurized oil that will come into action when you press your brake pedal. This pressure will actuate a piston that will push the brake pads on your brake disc which is attached to your wheel. When the brake pads will pinch the discs which will bring about your Mazda 6 to brake.
When to change the brake discs of a Mazda 6?
We will now move on to the section that most certainly attracts you to this content, namely, when replacing the brake discs of a Mazda 6? How we described it to you just before, the brake discs and pads work in osmosis, however these two elements are wearing parts and they will, with time and specifically the friction when braking wears out and loses braking power. We will now outline the different ways to know when to change them:
- We consider that generally the brake discs should be changed every 80, 000 – 100, 000 km on a Mazda 6 , however it is essential to know that dependent on your driving style and the type of journey this can change significantly. In fact, if you specifically drive on the motorway and your brakes are just slightly used, this amount can increase, in contrast, if you just drive in built-up areas, it can decrease.
- A basic and successful technique to identify the condition of the brake discs on your car is during the technical inspection. In fact this thorough control checks the state of your brakes and the controller will tell you if they are in good condition or need to be changed.
- A simple visual technique to know when to change the brake discs on your Mazda 6 is to remove the wheels after the vehicle has been set on stands. Once taken off, you will be able to access your discs and verify their condition. If they have any big scratches or deformations you will have to change them. Otherwise the second indicator to verify is to measure the depth of the disk in relation to its edge, if this value exceeds 1 mm you will have to change them by new ones.
.
How to change the brake discs on your Mazda 6?
Finally, to conclude this content we will quickly explain how to change the brake discs of your Mazda 6. You must know that if you change the brake discs of your car, you will absolutely have to change the brake pads of your Mazda 6, don’t hesitate to seek advice from our content which points out you how to make this change.
As far as changing discs is concerned, here are the main steps to follow:
- Put your Mazda 6 on stands, take off the wheels you want to work on.
- Using a large flat screwdriver, pry on your brake pads to compress the caliper piston as much as possible and have enough play to make all your changes.
- Using large Torx bits, remove the two nuts that lock the upper component of your brake caliper, remove it.
- Take out your brake pads, then unlock your brake discs thanks to the two torx screws on the side of the disc, you might need a mallet to remove the discs.
- Replace the discs and tighten them with the new torx screws provided, change your pads, reassemble the upper component of the caliper and tighten everything tightly.
- Mounting your wheels, and remember to do a 500-kilometer brake break-in before braking hard.
To find more tips on the Mazda 6, take a look at the Mazda 6 category.
