The safety of a car is essential. Whether or not the Honda E are economic holes, certain maintenance acts are vital. In this article we will explain to you when to replace the brake discs of your Honda E? To do this, to begin with, we will find out what the brake discs of your motor vehicle are used for, then, when to replace the brake discs of your Honda E, and, finally, how to replace them with new ones.
Benefit of the brake discs of a Honda E
We begin our content page by detailing what the brake discs of a Honda E are used for, it will enable you to understand why it is necessary to make sure that they are constantly in good working order.
Brake discs are the main part of your braking system. Obviously, braking on an Honda E is hydraulic, it is a system of hoses and pressurized oil that will come into action when you press your brake pedal. This pressure will actuate a piston that will push the brake pads on your brake disc which is installed on your wheel. When the brake pads will pinch the discs which will trigger your Honda E to brake.
When to replace the brake discs of a Honda E?
We will now proceed to the part that most certainly attracts you to this content page, namely, when replacing the brake discs of a Honda E? How we mentioned it to you just before, the brake discs and pads work in osmosis, however these two elements are wearing parts and they will, over time and especially the friction when braking wears out and loses braking power. We will now detail the different solutions to know when to replace them:
- We consider that generally speaking the brake discs should be changed every 80, 000 – 100, 000 km on a Honda E , however it is necessary to know that based on your driving style and the type of journey this can change considerably. Indeed, if you principally drive on the motorway and your brakes are only slightly used, this value can increase, on the other hand, if you only drive in built-up areas, it can reduce.
- A basic and good method to identify the state of the brake discs on your car is during the technical inspection. Indeed this thorough control checks the state of your brakes and the controller will tell you if they are in good state or need to be changed.
- A simple visual method to know when to replace the brake discs on your Honda E is to remove the wheels after the car has been set on stands. Once removed, you will have the ability to access your discs and verify their state. If they have any big scratches or deformations you will have to replace them. Otherwise the second indicator to verify is to measure the depth of the disk in relation to its edge, if this value exceeds 1 mm you will have to change them by new ones.
.
How to replace the brake discs on your Honda E?
Finally, to conclude this content page we will quickly describe how to replace the brake discs of your Honda E. You must know that if you replace the brake discs of your motor vehicle, you will absolutely have to change the brake pads of your Honda E, don’t hesitate to seek advice from our content page which exposes you how to make this replace.
As far as changing discs is concerned, here are the main steps to stick to:
- Put your Honda E on stands, take off the wheels you want to act on.
- Using a large flat screwdriver, pry on your brake pads to compress the caliper piston as much as possible and have enough play to make all your changes.
- Using large Torx bits, remove the two nuts that lock the upper part of your brake caliper, remove it.
- Remove your brake pads, then unlock your brake discs thanks to the two torx screws on the side of the disc, you might need a mallet to remove the discs.
- Replace the discs and tighten them with the new torx screws provided, replace your pads, reassemble the upper part of the caliper and tighten everything tightly.
- Mounting your wheels, and make sure to do a 500-kilometer brake break-in before braking hard.
If perhaps you have any additional questions about the Honda E, do not hesitate to consult our Honda E category.
