If you have a problem with your Jeep Wrangler, and you can’t identify where it’s originating from, don’t worry, we’re just here to help you discover solutions to these complications. If in your case, your Jeep Wrangler stops while driving , you must be more than worried by this problem. In this guide, we will help you to discover the cause of the problem. You will be delighted to discover, nevertheless, that a vehicle that stops while you are driving can cause quite a lot of different complications, so try to check out all of them from the point of view of how your Jeep Wrangler behaves when it dies while driving. To achieve this, we will now list all the parts that have been identified to be involved and the cause of their failure when the Jeep Wrangler dies while driving.
Jeep Wrangler THAT shuts off WHILE DRIVING: THE PARTS INVOLVED
We will in fact help you with your investigation on the origin of your Jeep Wrangler that dies while driving. Examine all parts that if damaged will be the cause of the problem you are going through.
THE EGR VALVE
The EGR valve is one of the parts that create quite a lot of hassle for drivers. Indeed, this valve has a habit of clogging up the more time passes or caused by a “quiet” driving of your Jeep Wrangler. This can result in poor exhaust gas diffusion and, when it is entirely clogged, a loss of power and possibly stalling at idle. Go through this comprehensive guide to EGR valve complications for more info.
A GROUND WIRE OR ELECTRICAL HASSLE
Does your Jeep Wrangler shuts off while driving? Don’t forget to look at your electrical system, if it’s a ground wire, for example, which can trigger a short circuit, or a entirely damaged electrical circuit that can no longer carry electricity. This is one of the most complicated causes to detect… We recommend that you try to discover a “burnt” part for the ground wire, which would present that an electric arc has formed between a cable and the bodywork, nevertheless you will definitely have to contact a professional to fix this problem.
IDLE ACTUATOR
The intent of this part is to control the engine idle speed of your Jeep Wrangler. If your Jeep Wrangler engine unit stops suddenly when you’re at a standstill, such as at a red light, verify the level of wear on your actuator.
THE FUEL PUMP
One of the most obvious causes, without fuel, the engine stops running. Occasionally, over the years, the fuel pump filter can become clogged or the fuel pump is weak and no longer pumping. Either technique, your Jeep Wrangler could get rid of while driving.
FUEL INJECTION SYSTEM
Same reflection as seen previously, nevertheless, in this circumstance it is the last phase of the fuel intake into the engine. Seized injectors, a defective injection pump or sensor and your Jeep Wrangler can go out of service or completely disable your fuel injection. An injection problem will usually appear when the fuel injection is hot.
NEIMAN ISSUE
A neiman, mainly concerning its ignition switch, will sometimes trigger you trouble and trigger your Jeep Wrangler to get rid of while driving. This part, which is necessary for starting your motor vehicle, as well serves as an anti-theft protection, which will prevent your Jeep Wrangler from running normally if it fails.
IGNITION COILS (PETROL ENGINE ONLY)
The penultimate main cause an Jeep Wrangler stops while driving is the ignition coil. This origin is just relevant for petrol cars since the engine runs by explosion and not by compression. In case your coils are too worn out, they will no longer spark. Look on that side.
BATTERY / ALTERNATOR
Finally, it is as well possible to be the victim of a tired battery or a damaged alternator. In both situations, the lack of energy stored inside the battery will prevent your Jeep Wrangler from running as it will no longer have the ability to power the main parts of your engine unit.
To find more tips on the Jeep Wrangler, take a look at the Jeep Wrangler category.
