If you’re a bit of a handy person, you’re most likely willing to manage the majority of the work to be done on your Toyota Sienna, but some are more difficult than others and necessitate the removal of body parts or elements to access the part you want to focus on. We want to help you in this process. That’s why in this article we are going to find out how to remove the bumper from a Toyota Sienna. This action is not very difficult and you should have the ability to do it with few equipment. To do so , first we will see how to remove the front bumper of your Toyota Sienna, then how to remove the rear bumper of this one.
How to remove the front bumper from a Toyota Sienna
So let’s begin our article content with the front bumper of your Toyota Sienna. To remove it, you will just need a set of ratchet wrenches, some screwdrivers and torx bits. Here are the guidelines you will have to follow in order to disassemble the bumper of your Toyota Sienna in good conditions:
- If you want to be more relaxed, we encourage you to lift your Toyota Sienna and to remove the front wheels to have a perfect access to the whole front bumper.
- Open the bonnet of your motor vehicle: Would seem obvious, but you will need to have access to the bumper attachment in your engine compartment.
- Take off the wheel arches: They’re also named fenders, but they’ll get in the way and prevent you from accessing all the screws on the front bumper of your Toyota Sienna. Dependant on your automobile features and the year of your model, you will also be able to find staples, to get this done, you will just have to use a staple extractor or to do it gently with a big flat screwdriver, and use a lever to open the staple.
- Then you will have to unscrew the screws that is behind your mudguard and that locks the front bumper of your Toyota Sienna on the sides.
- Unscrew the screws or remove the clips on the upper part of the bumper in the engine bay.
- Now it’s time to go beneath your Toyota Sienna to unscrew the bolts that are on the chassis of the automobile, you will find some in the middle of the bumper and on the sides.
- Make sure unplug the connection of the plate lighting and the distance control sensor if you have it.
- Carefully remove the front bumper by first unclipping the sides. If it doesn’t come off, you probably forgot a screw or a clip. Think of using a carpet or other to prevent that it gets scratched by touching the ground.
That’s it, you’ve seen all the steps of how to remove the front bumper from your Toyota Sienna, to put it back in place follow the steps in the opposite direction.
How to remove the rear bumper from a Toyota Sienna
And now, even if the procedure is quite equivalent, we will look at the case of removing the rear bumper from your Toyota Sienna. For each stage to avoid repeating ourselves we will simply give you the broad highlights, read the part 1 if you have any concerns or questions for more information.
- Start by executing the same first stage, that is, lift your Toyota Sienna and remove your rear wheels in order to have an optimal working space to remove the bumper of your Toyota Sienna without trouble
- Remove the rear wheel arches of your Toyota Sienna to access the side bumper side brackets
- Open your trunk
- Take off the side brackets in your wheel arches to make it less difficult to remove the bumper from your Toyota Sienna.
- Take away the lower bindings below your Toyota Sienna.
- At the same time, make sure to disconnect the rear license plate light and the reverse radar sensors if you are equipped with them.
- Unscrew the top brackets from the top of the trunk.
- Now all you have to do is remove the rear bumper from your Toyota Sienna, follow the same technique as for the front bumper
Here, you have learned through these two parts, how to remove the bumper from a Toyota Sienna whether it is the front one or the rear one the solutions are essentially the same and it is enough to be careful to make everything go well.
To get more tips on the Toyota Sienna, take a look at the Toyota Sienna category.
