You’re tired of listening to cassettes and only having the ability to enjoy the radio, while your smart phone is full of your preferred music but you don’t have a 3.5mm or usb port on your car radio, so you can’t enjoy your car travels to the fullest… That’s precisely why we’ve written and published this content to help you, because in this article you’re going to find out how to install a car radio on your Volkswagen California. To get this done, first of all we will see how to remove the old car radio, then how to install a car radio on Volkswagen California and to finish, how to connect it.
How to install car radio on Volkswagen California: Removing the old car stereo
Before we start the serious business of how to install a car stereo on your Volkswagen California, there is one important step, take out the audio set you already have on your car. There are two scenarios, either you have an original headunit, or you have an universal set. Before you start dismantling, always make sure to remove the negative wire from the battery to prevent any risk of short-circuit or electrocution. Once this is carried out, here are the two options according to the stereo that equips your Volkswagen California:
- Original car radio:
In this case, you’ll have to be persistent, in most cases, the simple use of extracting clamps in the 4 holes in the corners of the car radio should be enough to remove it. But on some specific models of specific years, this procedure will not be enough to remove the old car radio from your Volkswagen California. In actual fact, you will need to remove certain auto parts of the centre console to access the car radio itself. To get this done, you will need to use a screwdriver to remove the plastic covers that are in the way. Once you have access to the station, make sure to disconnect all the connections. - Aftermarket radio :
In this situation the operation is much easier, you will just have to use the extracting clamps and press on the 4 corners of your station to make it come out of its place. Once this step is carried out, make sure to unplug it and remove the metal frame that supports it in the notch of the center console. That’s it, you’ve finished dismantling your old car radio, all you have to do is install the new one!
How to install car radio on your Volkswagen California: Fitting and connecting the car radio
Let’s go to the essential step for you, how to install a car stereo on your Volkswagen California. Ahead of time, take some time to verify the suitability of your car and your headunit, and to read the installation information, which may give you specific recommendations.
Here are the various guidelines required in installing an aftermarket car radio. To begin with, put in place the metal frame provided with your new car radio, this frame has the job of holding your car radio in place on your Volkswagen California, once positioned, make sure to press the locking tabs on each side of the frame. Once this step has been completed, you will need to connect the three plugs of your car radio, two ISO connectors for power supply and sound transfer to the speakers of your Volkswagen California, then the radio antenna socket. For the latter, on some models you may need an adapter to transform it from male to female in order to adapt it to the socket of your new radio. At last, all you have to do is push your car radio into the metal frame, snap it into place, and position the plastic or metal frame provided with it on its contour. That’s it, you’ve just learned how to install a car radio on Volkswagen California, make sure to check that the radio is switched on, that the sound is working and that you’re picking up the radio and you’re ready to enjoy your new car radio. If you have other complications, or want to learn more about your car, don’t be reluctant to visit our page dedicated to it.
If perhaps you have any additional questions about the Volkswagen California, do not hesitate to consult our Volkswagen California category.
