You’re bored with listening to cassettes and only having the ability to enjoy the radio, while your smartphone is full of your favourite music but you don’t have a 3.5mm or usb port on your car radio, so you can’t appreciate your car trips to the fullest… That’s specifically why we’ve posted this article content to help you, because now you’re going to learn about how to install a car radio on your Dodge Avenger. To make this happen, first of all we will find out how to remove the old car radio, then how to install a car radio on Dodge Avenger and at last, how to connect it.
How to install car radio on Dodge Avenger: Removing the old car stereo
Before we begin the serious business of how to install a car stereo on your Dodge Avenger, there is one imperative task, take out the audio set you currently have on your car. There are two situations, either you have an original headunit, or you have an universal set. Before you start dismantling, always be sure you remove the negative wire from the battery to prevent any risk of short-circuit or electrocution. Once this is conducted, here are the two solutions depending on the stereo that equips your Dodge Avenger:
- Original car radio:
In this case, you’ll have to be patient, most of the time, the simple use of extracting clamps in the 4 holes in the corners of the car radio should be enough to remove it. But on some specific models of specific years, this procedure will not be enough to remove the old car radio from your Dodge Avenger. In actual fact, you will need to remove certain parts of the centre console to access the car radio itself. To do this, you will need to use a screwdriver to remove the plastic covers that are in the way. Once you have access to the station, be sure you disconnect all the connections. - Aftermarket radio :
In this scenario the technique is much easier, you will just have to use the extracting clamps and press on the 4 corners of your station to make it come out of its place. Once this step is conducted, be sure you unplug it and remove the metal frame that supports it in the notch of the center console. That’s it, you’ve accomplished dismantling your old car radio, all you have to do is install the new one!
How to install car radio on your Dodge Avenger: Fitting and connecting the car radio
Let’s go to the essential step for you, how to install a car stereo on your Dodge Avenger. Beforehand, spend some time to check the suitability of your car and your headunit, and to read the installation instructions, which may give you specific guidelines.
Here are the various steps required in installing an aftermarket car radio. First of all, put in place the metal frame provided with your new car radio, this frame has the job of holding your car radio in place on your Dodge Avenger, once installed, be sure you press the locking tabs on each side of the frame. Once this step has been done, you will need to connect the three plugs of your car radio, two ISO connectors for power supply and sound transfer to the speakers of your Dodge Avenger, then the radio antenna socket. For the latter, on some models you may need an adapter to transform it from male to female in order to adjust it to the socket of your new radio. Finally, all you have to do is push your car radio into the metal frame, snap it into place, and position the plastic or metal frame provided with it on its contour. That’s it, you’ve just discovered how to install a car radio on Dodge Avenger, be sure you check that the radio is switched on, that the sound is working and that you’re picking up the radio and you’re ready to enjoy your new car radio. If you have other concerns, or want to learn more about your car, don’t be reluctant to visit our page dedicated to it.
To find more tips on the Dodge Avenger, take a look at the Dodge Avenger category.
