You’re uninterested in listening to cassettes and only having the capability to enjoy the radio, while your smart phone is full of your favourite music file but you don’t have a 3.5mm or usb port on your car radio, so you can’t enjoy your car journeys to the fullest… That’s specifically why we’ve written this article content to help you, because in this article you’re going to learn about how to install a car radio on your Chevrolet Suburban. To do this, first we will see how to remove the old car radio, then how to install a car radio on Chevrolet Suburban and at last, how to connect it.
How to install car radio on Chevrolet Suburban: Removing the old car stereo
Before we get down to the serious business of how to install a car stereo on your Chevrolet Suburban, there is one imperative task, take away the audio set you already have on your car. There are two scenarios, either you have an original headunit, or you have an universal set. Before you start dismantling, always make sure to remove the negative wire from the battery to prevent any risk of short-circuit or electrocution. Once this is done, here are the two methods dependent on the stereo that equips your Chevrolet Suburban:
- Original car radio:
In this case, you’ll have to be patient, in general, the simple usage of extracting clamps in the 4 holes in the corners of the car radio should be enough to remove it. But on some specific models of specific years, this operation will not be enough to remove the old car radio from your Chevrolet Suburban. Actually, you will need to remove certain parts of the centre console to access the car radio itself. To get this done, you will need to use a screwdriver to remove the plastic covers that are in the way. Once you have access to the station, make sure to disconnect all the connections. - Aftermarket radio :
In this circumstance the technique is much easier, you will just have to use the extracting clamps and press on the 4 corners of your station to make it come out of its place. Once this step is done, make sure to unplug it and remove the metal frame that supports it in the notch of the center console. That’s it, you’ve ended dismantling your old car radio, all you have to do is install the new one!
How to install car radio on your Chevrolet Suburban: Fitting and connecting the car radio
Let’s go to the most important section for you, how to install a car stereo on your Chevrolet Suburban. Beforehand, take the time to verify the compatibility of your car and your headunit, and to read the installation instructions, which may give you specific instructions.
Here are the various guidelines involved in installing an aftermarket car radio. To begin with, put in place the metal frame provided with your new car radio, this frame has the role of holding your car radio in place on your Chevrolet Suburban, once situated, make sure to press the locking tabs on each side of the frame. Once this step has been carried out, you will need to connect the three plugs of your car radio, two ISO connectors for power supply and sound transfer to the speakers of your Chevrolet Suburban, then the radio antenna socket. For the latter, on some models you may need an adapter to transform it from male to female to be able to adjust it to the socket of your new radio. Finally, all you have to do is push your car radio into the metal frame, snap it into place, and position the plastic or metal frame provided with it on its contour. That’s it, you’ve just discovered how to install a car radio on Chevrolet Suburban, make sure to check that the radio is switched on, that the sound is working and that you’re picking up the radio and you’re ready to enjoy your new car radio. If you have other problems, or want to learn more about your car, don’t be reluctant to visit our page dedicated to it.
To find more tips on the Chevrolet Suburban, take a look at the Chevrolet Suburban category.
