How to disable the immobiliser Mercury Milan ?

Your Mercury Milan doesn’t start anymore? Have you analyzed everything? Battery, alternator, spare keys… And you feel like the issue emanates from your immobiliser ? It is quite plausible, indeed that it is in question if your car no longer wants to start or stalls when starting without a reason. You want to disable the immobiliser on your Mercury Milan ? You are on the good website, we have made this post to help you see more clearly and resolve your problems related to this element. First, we will see how the immobiliser works on your Mercury Milan, then the different techniques to disable it.

How your immobiliser system works on Mercury Milan

Before detailing the different solutions available to you, here is a short intro to show you the intent and operation of the immobilizer in your Mercury Milan. This electronic element was invented 30 years ago and aims to prevent the theft of your Mercury Milan. Indeed, thanks to a transponder and an antenna (coil) included in the key, and, a immobilisation control box included in the ECU and a reception antenna on the neiman, your Mercury Milan will go each time you put the key in the ignition, it controls that the code emitted by your key is indeed the one expected by your immobilization box. It is only at this instant, that it will permit you to turn on your car. It is thanks to RFID technology (chip in the key) that this device will work.

First technique, your key no longer enables your Mercury Milan to start, you want to turn off the immobiliser of your Mercury Milan, but first of all you should try this technique to start it and take it to a garage verify that you can not execute a less important procedure to restore the normal start of your car. Indeed, with your car you should have a spare key (which you should try and which should start your Mercury Milan), but if you don’t have it you should at least have the “code card”, it contains the start code. Thanks to this code, you will still be able to start your car by entering it manually. To do this, turn on the ignition, use your centralized button to enter the digits, several quick presses (example: 2 for digit 2) then a stop of one and a half seconds to validate the digit and resume, duplicate the procedure until you have entered the whole code. This should allow your Mercury Milan to start without having to remove the immobiliser.

Repair your key at a key specialist or your dealer

If even though a battery swap, several attempts to enter the immobiliser code on your Mercury Milan still doesn’t work, it’s likely your key that’s at issue. We can understand that you still want to bypass the immobiliser device from your Mercury Milan. Indeed, your transponder must have been affected or must have fallen off your key. To correct this issue, only solution, go to a key specialist (also available on the internet) or, at your car dealership who can repair your Mercury Milan key. Depending on who you go to the repair should cost you about 100 euros if you still have a copy or your “code card” and about 350 euros at your car dealership if you have no support and you want a new functional key, it will avoid you having to remove the immobilizer from your Mercury Milan.

Manually remove your immobilizer

Although you may be tempted to bypass the immobilizer from your Mercury Milan, this is not recommended at all for several reasons. First your Mercury Milan would be much more vulnerable to theft attempts. Indeed, without an immobiliser box, simply doing “the wires” may be enough to turn your car on. Moreover to that, your insurance, in case of theft most likely won’t refund you if it finds out that the immobiliser on your Mercury Milan has been removed, bypassed or deactivated. This if you still want to do it, some websites online still give the method, we have made the choice not to disclose it, because it could help people with bad intentions.

In the event that you have any additional questions about the Mercury Milan, do not hesitate to consult our Mercury Milan category.