If you want to have a clean vehicle or you intend to sell your car, cleaning the engine of your Peugeot Partner is an act of routine service that is not necessarily well managed, between the fear of damaging electronic parts or not knowing which products to use… On this page, we will join you to execute this act of routine service with serenity. To do this, first, we will see why it might be important to clean the engine unit of your car, and, in a second step, how to clean the engine unit of your Peugeot Partner .

clean-engine-peugeot-partner

Why clean the engine of your Peugeot Partner?

So we start our content by detailing why it might be good to reflect on a cleaning of the engine unit block of your Peugeot Partner .

The most general justification for cleaning the engine unit compartment of your car should be regular service. Failure to clean your car will cause dirt and grime to gather and sooner or later damage auto parts of your car. We encourage you to perform this cleaning between 1 and 2 times a year. It can also be interesting to clean your engine before selling your Peugeot Partner, nevertheless be careful not to clean it too much, potential buyers might think that a too clean engine is associated with a leaking engine that tries to be camouflaged by a complete cleaning, better to have a healthy engine unit than a too clean engine.

How to clean the engine unit of your Peugeot Partner?

We will now begin the heart of the content with the practical part of cleaning the engine unit block of your Peugeot Partner . To do this, in the first part we will concentrate on the preparation to do on your engine unit to conduct this act properly, and in a second time, the guidelines to enable you to clean the engine compartment of your Peugeot Partner.

To prepare the engine of your Peugeot Partner before cleaning it

.
First step and not the least necessary one. Even if your car’s engine compartment is supposed to be waterproof, cleaning it totally is not recommended either because of the many electrical parts inside. Therefore, before you clean the engine of your Peugeot Partner totally, it is better to protect the electrical parts of your Peugeot Partner . Here are the steps to take to protect your car’s engine unit effectively:

  • Disconnect and remove the battery from your Peugeot Partner , for this, do not think twice to seek advice from our content dedicated to this subject if you don’t know how to achieve this step.
  • Remove the upper motor housing of your Peugeot Partner , it’s a plastic cover that can usually be removed by unscrewing a few screws. This will enable you to have an less difficult access to the whole engine unit of your car.
  • Protect all electrical parts with plastic film , stretchable for example, this involves the flowmeter (which is found on your air inlet), the alternator, all electrical cables and the fuse box

.

Cleaning of the engine unit compartment of a Peugeot Partner

Now that you have prepared your car for cleaning, all you have to do is commence cleaning it, here are the steps to follow to clean the engine unit of your Peugeot Partner effectively :

  • Warm up the engine unit of your car for about 5 minutes, this will produce the grease more fluid and facilitate its elimination.
  • Use a strong> engine unit degreaser and spray generously on all visible parts of your Peugeot Partner engine unit.
  • Let it operate for five to ten minutes.
  • Do not use a high-pressure cleaner, as this may damage parts of your engine unit. So use a garden hose and rise with plenty of water.
  • If you are satisfied with the end result, you can dry your engine unit with a compressor, if there are traces of grease remaining, you can replicate the procedure until it disappears.
  • Last little piece of suggestions, if you want and have the budget, you can apply a layer of motor protection, this will prevent the accumulation of dirt on the engine unit of your Peugeot Partner, you will find this sort of product in specific stores or in the category of products for boat motors

.
All you have to do is clean the work area, refit your engine crankcase, reconnect your battery and you’ll be able to get back on the road with a clean engine unit.

If you need more tutorials on the Peugeot Partner, go to our Peugeot Partner category.