You’ve most likely already read about the renowned EGR valve, the anti-pollution valve. It is not always appreciated by motorists because it has a tendency to cause more problems than anything else… Indeed, depending on the use you are going to make of your car, it can become blocked and cause you a lot of complications. If this is the situation, you are most likely concerned about how to clean the EGR valve of your Ford Taurus ? Don’t stress, we’ve prepared this article content to help you with this task. To achieve this, we will first check out the role of the EGR valve, then what are the failures that the EGR valve of your Ford Taurus can reason and to finish the section that will most likely appeal you the most, how to clean the EGR valve Ford Taurus?
How to Clean your Ford Taurus EGR Valve: Role and Operation
Goal of the EGR valve
The EGR valve of your car has been added to diesel engines principally to lower pollution emitted by cars and to match EURO measures on Ford Taurus . It will as a result influence the quality of exhaust gas output and eradicate toxic particles, mainly Nitrogen Oxide.
Operation of the EGR valve
Before we learn how to clean the EGR valve on your Ford Taurus , we will take a look at how it operates. As seen before, its objective is to clean the exhaust gases, so it will be located at the engine outlet, thanks to a valve, it will be able to return the unburned exhaust gases to the engine for a second burn which will eradicate all unburned toxic particles. It will work principally at low speed because at high speed the combustion is enough to burn all these gases.
How to clean your Ford Taurus EGR valve: Identifying faults
The EGR valve, although very beneficial to limit the pollution emissions of your Ford Taurus , will unfortunately tend to clog up because of soot/gas deposits that will accumulate in its mechanism, which will finally risk blocking the operation of the valve, until totally blocking the engine unit, here are the signs of illness that a defective EGR valve on your Ford Taurus can cause:
- Motor light on
- Performance loss
- Technical inspection rejected
- Black gases
- Car that grazes at low speed
- Low RPM settings
How to clean your Ford Taurus EGR valve: In practice
And now we’ll start the section you are most enthusiastic about, how to clean the EGR valve of your car. Here are the two ways that you can use.
Do it yourself
How to clean your Ford Taurus EGR valve system: Without taking it apart
Despite the fact this process is less effective, it is however possible to consider a “rough” cleaning of your EGR valve, the reality is, you will only need to use fuel additives, equivalent to the products used to clean the injection. These particular solutions must be injected into the running engine, at the right operating temperature, diluted in about 20 litres of fuel and run the engine for 3 or 4 minutes in high rev to clean the EGR valve of your Ford Taurus.
How to clean your car EGR valve: With disassembly
Here is the best process, which will require enough access to the EGR valve to accomplish the operation yourself. If so, the process is fairly easy. You will need to disconnect the electromagnet from the EGR valve, remove the few screws that hold it in place, and remove it. Once these simple steps are achieved, now comes the time for cleaning. To accomplish this, you will need to use a product such as solvent, petrol, oven cleaning product, which you will leave to act for ten minutes, then scrape off the rest using a scraper, finish cleaning with wire brush. If you want to go further, you can even clean the two canal on which it is connected which may be scorched, for this, use a scraper and a vacuum cleaner to avoid dropping deposits in the conduits. You will only have to reassemble it and you will have finished cleaning the EGR valve of your Ford Taurus.
Have it done by a professional
If, your EGR valve is not reachable because of the series or the engine of your car and if removing it would cause too many difficulties (removing too many elements that hinder access for example), how to clean the EGR valve of your Ford Taurus? In this instance, it would be better rather than launching yourself into an overly complex task, you turn to an auto mechanic. He will be able to do the job more cleanly and will be able, if required, to change the valve if it is dead. The cost of cleaning depending on the difficulty of access is between 70 and 300 €.
Remove the EGR valve of your Ford Taurus
Finally, a number of people make a more radical decision to limit the risk of a failed valve. Instead of cleaning the EGR valve of their Ford Taurus, they just prefer to block it in the closed position. This treatment will have the effect of greatly increasing the pollution emitted by the car, of no longer complying with pollution standards, of having an engine warning light all day on and finally risk fouling the engine. We strongly recommend against making this choice. If you have other questions or want to learn more about your car, don’t be reluctant to take a look at our dedicated page.
In the event that you have any further questions about the Ford Taurus, do not hesitate to consult our Ford Taurus category.
