It doesn’t matter if it’s for your own safety, for roadworthiness testing or to avoid a fine, ensuring that your headlamp bulbs are always working is important and vital. In reality, bulbs are wearing parts that will undoubtedly burn out after some time and as a result need to be replaced. You’re almost certainly on this website because one of your position lamp is burnt out and you’re thinking about how to change the bulb of my GMC Canyon parking light, we’ve posted this article content to help you do this procedure on your own and not need to go to your auto technician. In a first part, we will take a look at changing the front daytime running light bulb of your car and in a second section, how to swap the rear daytime running light.

change-parking-light-gmc-canyon

How to swap the front parking light bulb of my GMC Canyon?

We will begin this content page with changing the front daytime running light bulb of your GMC Canyon, be aware that according to the year and finish of your car it may not be quite the same approach to use. In reality, even if the location of your bulb is not going to change, the access may be more or less difficult based on the features of your car.

First approach, we will conduct the bulb change of your daytime running light without removing the headlight of your GMC Canyon. Although this process is the easiest, it is not guaranteed that you will be able to perform it on your vehicle without encumbrance. In reality, depending on the versions and the year, on some versions there will not be enough space for you to swap the bulb like this. Here are the two different solutions to swap the bulb of the front parking light of your GMC Canyon:.

  • Going through the bonnet of your car: First approach, you will simply go through the bonnet of your vehicle to direct access your headlight unit. This is the most logical technique but it is not always easy to do to realise, sometimes because of secondary auto parts that will obstruct your access. To accomplish this, here are the basic steps to carry out. First, with the engine off, disconnect the terminals of your battery to avoid any short circuit or risk of electrocution. Now that this stage has been done, you will need to access the back of your headlight unit to swap the daytime running light bulb on your GMC Canyon. You may perhaps need to take out the battery for easier access. In such a case, you will need to open the bulb protection cap on your headlight (¼ usually does the job), then you will need to take out the bulb socket from its position. To accomplish this, pull carefully on the socket and not on the wires (you risk damaging them), at last once the socket is out, you can swap your parking lamps bulb, being very careful not to damage the wires and use a cloth to avoid dirtying your new bulb. Once done, reassemble the set up, reconnect your battery and execute a check test before taking to the road.
  • By removing the crosshair grill and the headlight:
  • Second solution, you can remove the headlight of your GMC Canyon in cases where the access through the engine block seems too obstructed. To accomplish this, you just have to open your bonnet, take out the front grill held by only a few torx screws, then take out the headlight in question. Once these actions are completed you will just have to stick to the same method as on the previous part to swap the front daytime running light bulb of your GMC Canyon

.

How to swap the rear parking light bulb on your GMC Canyon

To finish , if you wish to change the rear parking light bulb of your GMC Canyon the approach is much easier, here are the different guidelines to stick to to allow you to change this bulb:

  • Disconnect your battery
  • Get the floorboards out of the trunk.
  • Unscrew the back cover of the headlight unit from your car.
  • After finding the rear position lamps bulb on your car, remove the burnt-out bulb.
  • Place your new parking light bulb into the headlamp assembly on your car
  • Reassemble the whole thing.

Check that your parking lights are operating correctly again before you set off again and you’re done. If you want to change the fog light bulb on your GMC Canyon, please browse our dedicated content page to learn how to do it.

If you want more guides on the GMC Canyon, go to our GMC Canyon category.